提交 6a724d68 编写于 作者: M Michael Buesch 提交者: David S. Miller

[B43]: Remove the "radio hw enabled" message on startup.

This message is useless. Only report state changes.

Cc: Larry Finger <larry.finger@lwfinger.net>
Signed-off-by: NMichael Buesch <mb@bu3sch.de>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
上级 61609bc0
......@@ -2227,9 +2227,6 @@ static int b43_chip_init(struct b43_wldev *dev)
if (err)
goto err_gpio_cleanup;
b43_radio_turn_on(dev);
dev->radio_hw_enable = b43_is_hw_radio_enabled(dev);
b43dbg(dev->wl, "Radio %s by hardware\n",
dev->radio_hw_enable ? "enabled" : "disabled");
b43_write16(dev, 0x03E6, 0x0000);
err = b43_phy_init(dev);
......@@ -3252,6 +3249,9 @@ static void setup_struct_wldev_for_init(struct b43_wldev *dev)
{
/* Flags */
dev->reg124_set_0x4 = 0;
/* Assume the radio is enabled. If it's not enabled, the state will
* immediately get fixed on the first periodic work run. */
dev->radio_hw_enable = 1;
/* Stats */
memset(&dev->stats, 0, sizeof(dev->stats));
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册