mac80211: stop tx before doing hw config and rate update

The assumption is that during the hw config, transmission was
already stopped by mac80211. Sometimes the AP can be switching
b/w the ht modes due to intolerant or etc where STA is in
the middle of transmission. In such scenario, buffer overflow
was observed at driver side. And also before updating the rate
control, the frames are continued to xmited with older rates.
This patch ensures that the frames are always xmitted with
updated rates and avoid buffer overflow.
Signed-off-by: NRajkumar Manoharan <rmanohar@qca.qualcomm.com>
Reviewed-by: NJohannes Berg <johannes@sipsolutions.net>
Signed-off-by: NJohn W. Linville <linville@tuxdriver.com>

net/mac80211/ieee80211_i.h

@@ -671,6 +671,7 @@ enum queue_stop_reason {
 	IEEE80211_QUEUE_STOP_REASON_AGGREGATION,
 	IEEE80211_QUEUE_STOP_REASON_SUSPEND,
 	IEEE80211_QUEUE_STOP_REASON_SKB_ADD,
+	IEEE80211_QUEUE_STOP_REASON_CHTYPE_CHANGE,
 };
 
 #ifdef CONFIG_MAC80211_LEDS

net/mac80211/mlme.c

@@ -1918,8 +1918,24 @@ static void ieee80211_rx_mgmt_beacon(struct ieee80211_sub_if_data *sdata,
 
 		rcu_read_unlock();
 
+		/*
+		 * Whenever the AP announces the HT mode change that can be
+		 * 40MHz intolerant or etc., it would be safer to stop tx
+		 * queues before doing hw config to avoid buffer overflow.
+		 */
+		ieee80211_stop_queues_by_reason(&sdata->local->hw,
+				IEEE80211_QUEUE_STOP_REASON_CHTYPE_CHANGE);
+
+		/* flush out all packets */
+		synchronize_net();
+
+		drv_flush(local, false);
+
 		changed |= ieee80211_enable_ht(sdata, elems.ht_info_elem,
 					       bssid, ap_ht_cap_flags);
+
+		ieee80211_wake_queues_by_reason(&sdata->local->hw,
+				IEEE80211_QUEUE_STOP_REASON_CHTYPE_CHANGE);
 	}
 
 	/* Note: country IE parsing is done for us by cfg80211 */