提交 668018d7 编写于 作者: B Bruce Allan 提交者: Jeff Kirsher

e1000e: remove unnecessary parentheses

Signed-off-by: NBruce Allan <bruce.w.allan@intel.com>
Tested-by: NAaron Brown <aaron.f.brown@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>
上级 fe1e980f
......@@ -1865,7 +1865,7 @@ static void e1000_power_down_phy_copper_82571(struct e1000_hw *hw)
struct e1000_phy_info *phy = &hw->phy;
struct e1000_mac_info *mac = &hw->mac;
if (!(phy->ops.check_reset_block))
if (!phy->ops.check_reset_block)
return;
/* If the management interface is not enabled, then power down */
......
......@@ -1088,7 +1088,7 @@ static int e1000_setup_desc_rings(struct e1000_adapter *adapter)
tx_ring->buffer_info = kcalloc(tx_ring->count,
sizeof(struct e1000_buffer),
GFP_KERNEL);
if (!(tx_ring->buffer_info)) {
if (!tx_ring->buffer_info) {
ret_val = 1;
goto err_nomem;
}
......@@ -1150,7 +1150,7 @@ static int e1000_setup_desc_rings(struct e1000_adapter *adapter)
rx_ring->buffer_info = kcalloc(rx_ring->count,
sizeof(struct e1000_buffer),
GFP_KERNEL);
if (!(rx_ring->buffer_info)) {
if (!rx_ring->buffer_info) {
ret_val = 5;
goto err_nomem;
}
......
......@@ -511,8 +511,8 @@ s32 e1000e_check_for_fiber_link(struct e1000_hw *hw)
* was just plugged in. The autoneg_failed flag does this.
*/
/* (ctrl & E1000_CTRL_SWDPIN1) == 1 == have signal */
if ((ctrl & E1000_CTRL_SWDPIN1) && (!(status & E1000_STATUS_LU)) &&
(!(rxcw & E1000_RXCW_C))) {
if ((ctrl & E1000_CTRL_SWDPIN1) && !(status & E1000_STATUS_LU) &&
!(rxcw & E1000_RXCW_C)) {
if (mac->autoneg_failed == 0) {
mac->autoneg_failed = 1;
return 0;
......@@ -577,7 +577,7 @@ s32 e1000e_check_for_serdes_link(struct e1000_hw *hw)
* time to complete.
*/
/* (ctrl & E1000_CTRL_SWDPIN1) == 1 == have signal */
if ((!(status & E1000_STATUS_LU)) && (!(rxcw & E1000_RXCW_C))) {
if (!(status & E1000_STATUS_LU) && !(rxcw & E1000_RXCW_C)) {
if (mac->autoneg_failed == 0) {
mac->autoneg_failed = 1;
return 0;
......
......@@ -78,7 +78,7 @@ static s32 e1000_mng_enable_host_if(struct e1000_hw *hw)
u32 hicr;
u8 i;
if (!(hw->mac.arc_subsystem_valid)) {
if (!hw->mac.arc_subsystem_valid) {
e_dbg("ARC subsystem not valid.\n");
return -E1000_ERR_HOST_INTERFACE_COMMAND;
}
......
......@@ -132,7 +132,7 @@ s32 e1000e_get_phy_id(struct e1000_hw *hw)
u16 phy_id;
u16 retry_count = 0;
if (!(phy->ops.read_reg))
if (!phy->ops.read_reg)
goto out;
while (retry_count < 2) {
......@@ -382,7 +382,7 @@ static s32 __e1000e_read_phy_reg_igp(struct e1000_hw *hw, u32 offset, u16 *data,
s32 ret_val = 0;
if (!locked) {
if (!(hw->phy.ops.acquire))
if (!hw->phy.ops.acquire)
goto out;
ret_val = hw->phy.ops.acquire(hw);
......@@ -453,7 +453,7 @@ static s32 __e1000e_write_phy_reg_igp(struct e1000_hw *hw, u32 offset, u16 data,
s32 ret_val = 0;
if (!locked) {
if (!(hw->phy.ops.acquire))
if (!hw->phy.ops.acquire)
goto out;
ret_val = hw->phy.ops.acquire(hw);
......@@ -526,7 +526,7 @@ static s32 __e1000_read_kmrn_reg(struct e1000_hw *hw, u32 offset, u16 *data,
s32 ret_val = 0;
if (!locked) {
if (!(hw->phy.ops.acquire))
if (!hw->phy.ops.acquire)
goto out;
ret_val = hw->phy.ops.acquire(hw);
......@@ -599,7 +599,7 @@ static s32 __e1000_write_kmrn_reg(struct e1000_hw *hw, u32 offset, u16 data,
s32 ret_val = 0;
if (!locked) {
if (!(hw->phy.ops.acquire))
if (!hw->phy.ops.acquire)
goto out;
ret_val = hw->phy.ops.acquire(hw);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册