tty: stop defining STD_COM_FLAGS in drivers

STD_COM_FLAGS is mostly a bad name for what the drivers thinks it is.
Stop using it and pass the flags directly.

cyclades defines it as 0, so we do not assign anything to freshly
tty_port_init'ed structure.
Signed-off-by: NJiri Slaby <jslaby@suse.cz>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

arch/xtensa/platforms/xt2000/setup.c

@@ -113,7 +113,6 @@ void platform_heartbeat(void)
 }
 
 //#define RS_TABLE_SIZE 2
-//#define STD_COM_FLAGS (UPF_BOOT_AUTOCONF|UPF_SKIP_TEST)
 
 #define _SERIAL_PORT(_base,_irq)					\
 {									\

drivers/tty/cyclades.c

@@ -93,8 +93,6 @@ static void cy_send_xchar(struct tty_struct *tty, char ch);
 #define	SERIAL_XMIT_SIZE	(min(PAGE_SIZE, 4096))
 #endif
 
-#define STD_COM_FLAGS (0)
-
 /* firmware stuff */
 #define ZL_MAX_BLOCKS	16
 #define DRIVER_VERSION	0x02010203
@@ -3083,7 +3081,6 @@ static int cy_init_card(struct cyclades_card *cinfo)
 
 		info->port.closing_wait = CLOSING_WAIT_DELAY;
 		info->port.close_delay = 5 * HZ / 10;
-		info->port.flags = STD_COM_FLAGS;
 		init_completion(&info->shutdown_wait);
 
 		if (cy_is_Z(cinfo)) {

drivers/tty/serial/m32r_sio.c

@@ -51,9 +51,6 @@
 
 #define PASS_LIMIT	256
 
-/* Standard COM flags */
-#define STD_COM_FLAGS (UPF_BOOT_AUTOCONF | UPF_SKIP_TEST)
-
 static const struct {
 	unsigned int port;
 	unsigned int irq;
@@ -892,7 +889,7 @@ static void __init m32r_sio_init_ports(void)
 		up->port.iobase   = old_serial_port[i].port;
 		up->port.irq      = irq_canonicalize(old_serial_port[i].irq);
 		up->port.uartclk  = BAUD_RATE * 16;
-		up->port.flags    = STD_COM_FLAGS;
+		up->port.flags    = UPF_BOOT_AUTOCONF | UPF_SKIP_TEST;
 		up->port.membase  = 0;
 		up->port.iotype   = 0;
 		up->port.regshift = 0;