提交 609adfc2 编写于 作者: B Brian Foster 提交者: Dave Chinner

xfs: debug mode log record crc error injection

XFS now uses CRC verification over a limited section of the log to
detect torn writes prior to a crash. This is difficult to test directly
due to the timing and hardware requirements to cause a short write.

Add a mechanism to inject CRC errors into log records to facilitate
testing torn write detection during log recovery. This mechanism is
dangerous and can result in filesystem corruption. Thus, it is only
available in DEBUG mode for testing/development purposes. Set a non-zero
value to the following sysfs entry to enable error injection:

	/sys/fs/xfs/<dev>/log/log_badcrc_factor

Once enabled, XFS intentionally writes an invalid CRC to a log record at
some random point in the future based on the provided frequency. The
filesystem immediately shuts down once the record has been written to
the physical log to prevent metadata writeback (e.g., AIL insertion)
once the log write completes. This helps reasonably simulate a torn
write to the log as the affected record must be safe to discard. The
next mount after the intentional shutdown requires log recovery and
should detect and recover from the torn write.

Note again that this _will_ result in data loss or worse. For testing
and development purposes only!
Signed-off-by: NBrian Foster <bfoster@redhat.com>
Reviewed-by: NDave Chinner <dchinner@redhat.com>
Signed-off-by: NDave Chinner <david@fromorbit.com>
上级 7088c413
......@@ -1188,10 +1188,16 @@ xlog_iodone(xfs_buf_t *bp)
int aborted = 0;
/*
* Race to shutdown the filesystem if we see an error.
* Race to shutdown the filesystem if we see an error or the iclog is in
* IOABORT state. The IOABORT state is only set in DEBUG mode to inject
* CRC errors into log recovery.
*/
if (XFS_TEST_ERROR(bp->b_error, l->l_mp,
XFS_ERRTAG_IODONE_IOERR, XFS_RANDOM_IODONE_IOERR)) {
if (XFS_TEST_ERROR(bp->b_error, l->l_mp, XFS_ERRTAG_IODONE_IOERR,
XFS_RANDOM_IODONE_IOERR) ||
iclog->ic_state & XLOG_STATE_IOABORT) {
if (iclog->ic_state & XLOG_STATE_IOABORT)
iclog->ic_state &= ~XLOG_STATE_IOABORT;
xfs_buf_ioerror_alert(bp, __func__);
xfs_buf_stale(bp);
xfs_force_shutdown(l->l_mp, SHUTDOWN_LOG_IO_ERROR);
......@@ -1838,6 +1844,23 @@ xlog_sync(
/* calculcate the checksum */
iclog->ic_header.h_crc = xlog_cksum(log, &iclog->ic_header,
iclog->ic_datap, size);
#ifdef DEBUG
/*
* Intentionally corrupt the log record CRC based on the error injection
* frequency, if defined. This facilitates testing log recovery in the
* event of torn writes. Hence, set the IOABORT state to abort the log
* write on I/O completion and shutdown the fs. The subsequent mount
* detects the bad CRC and attempts to recover.
*/
if (log->l_badcrc_factor &&
(prandom_u32() % log->l_badcrc_factor == 0)) {
iclog->ic_header.h_crc &= 0xAAAAAAAA;
iclog->ic_state |= XLOG_STATE_IOABORT;
xfs_warn(log->l_mp,
"Intentionally corrupted log record at LSN 0x%llx. Shutdown imminent.",
be64_to_cpu(iclog->ic_header.h_lsn));
}
#endif
bp->b_io_length = BTOBB(count);
bp->b_fspriv = iclog;
......@@ -2791,11 +2814,19 @@ xlog_state_do_callback(
}
} while (!ioerrors && loopdidcallbacks);
#ifdef DEBUG
/*
* make one last gasp attempt to see if iclogs are being left in
* limbo..
* Make one last gasp attempt to see if iclogs are being left in limbo.
* If the above loop finds an iclog earlier than the current iclog and
* in one of the syncing states, the current iclog is put into
* DO_CALLBACK and the callbacks are deferred to the completion of the
* earlier iclog. Walk the iclogs in order and make sure that no iclog
* is in DO_CALLBACK unless an earlier iclog is in one of the syncing
* states.
*
* Note that SYNCING|IOABORT is a valid state so we cannot just check
* for ic_state == SYNCING.
*/
#ifdef DEBUG
if (funcdidcallbacks) {
first_iclog = iclog = log->l_iclog;
do {
......@@ -2810,7 +2841,7 @@ xlog_state_do_callback(
* IOERROR - give up hope all ye who enter here
*/
if (iclog->ic_state == XLOG_STATE_WANT_SYNC ||
iclog->ic_state == XLOG_STATE_SYNCING ||
iclog->ic_state & XLOG_STATE_SYNCING ||
iclog->ic_state == XLOG_STATE_DONE_SYNC ||
iclog->ic_state == XLOG_STATE_IOERROR )
break;
......
......@@ -62,6 +62,7 @@ static inline uint xlog_get_client_id(__be32 i)
#define XLOG_STATE_CALLBACK 0x0020 /* Callback functions now */
#define XLOG_STATE_DIRTY 0x0040 /* Dirty IC log, not ready for ACTIVE status*/
#define XLOG_STATE_IOERROR 0x0080 /* IO error happened in sync'ing log */
#define XLOG_STATE_IOABORT 0x0100 /* force abort on I/O completion (debug) */
#define XLOG_STATE_ALL 0x7FFF /* All possible valid flags */
#define XLOG_STATE_NOTUSED 0x8000 /* This IC log not being used */
......@@ -410,6 +411,8 @@ struct xlog {
/* The following field are used for debugging; need to hold icloglock */
#ifdef DEBUG
void *l_iclog_bak[XLOG_MAX_ICLOGS];
/* log record crc error injection factor */
uint32_t l_badcrc_factor;
#endif
};
......
......@@ -255,11 +255,47 @@ write_grant_head_show(
}
XFS_SYSFS_ATTR_RO(write_grant_head);
#ifdef DEBUG
STATIC ssize_t
log_badcrc_factor_store(
struct kobject *kobject,
const char *buf,
size_t count)
{
struct xlog *log = to_xlog(kobject);
int ret;
uint32_t val;
ret = kstrtouint(buf, 0, &val);
if (ret)
return ret;
log->l_badcrc_factor = val;
return count;
}
STATIC ssize_t
log_badcrc_factor_show(
struct kobject *kobject,
char *buf)
{
struct xlog *log = to_xlog(kobject);
return snprintf(buf, PAGE_SIZE, "%d\n", log->l_badcrc_factor);
}
XFS_SYSFS_ATTR_RW(log_badcrc_factor);
#endif /* DEBUG */
static struct attribute *xfs_log_attrs[] = {
ATTR_LIST(log_head_lsn),
ATTR_LIST(log_tail_lsn),
ATTR_LIST(reserve_grant_head),
ATTR_LIST(write_grant_head),
#ifdef DEBUG
ATTR_LIST(log_badcrc_factor),
#endif
NULL,
};
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册