[SCSI] qla2xxx: Use correct value for max vport in LOOP topology.

Use minimum value for max vport during firmware initialization in LOOP
topology. Using max vport value from get resource count in LOOP topology
causes firmware initialization failure.
Signed-off-by: NLalit Chandivade <lalit.chandivade@qlogic.com>
Signed-off-by: NAndrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: NJames Bottomley <James.Bottomley@HansenPartnership.com>

drivers/scsi/qla2xxx/qla_init.c

@@ -1308,8 +1308,12 @@ qla2x00_init_rings(scsi_qla_host_t *vha)
 
 	DEBUG(printk("scsi(%ld): Issue init firmware.\n", vha->host_no));
 
-	if (ha->flags.npiv_supported)
+	if (ha->flags.npiv_supported) {
+		if (ha->operating_mode == LOOP)
+			ha->max_npiv_vports = MIN_MULTI_ID_FABRIC - 1;
 		mid_init_cb->count = cpu_to_le16(ha->max_npiv_vports);
+	}
+
 
 	mid_init_cb->options = __constant_cpu_to_le16(BIT_1);