drivers/tty/serial/crisv10.c: remove dead #ifdef block

ETRAX_EXTERN_PB6CLK_ENABLED is not defined in Kconfig.  The affected
 #ifdef block has not been compiled for years, so remove it entirely.
Signed-off-by: NValentin Rothberg <valentinrothberg@gmail.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/tty/serial/crisv10.c

@@ -2867,19 +2867,6 @@ change_speed(struct e100_serial *info)
 			*R_SERIAL_PRESCALE = divisor;
 			info->baud = SERIAL_PRESCALE_BASE/divisor;
 		}
-#ifdef CONFIG_ETRAX_EXTERN_PB6CLK_ENABLED
-		else if ((info->baud_base==CONFIG_ETRAX_EXTERN_PB6CLK_FREQ/8 &&
-			  info->custom_divisor == 1) ||
-			 (info->baud_base==CONFIG_ETRAX_EXTERN_PB6CLK_FREQ &&
-			  info->custom_divisor == 8)) {
-				/* ext_clk selected */
-				alt_source =
-					IO_STATE(R_ALT_SER_BAUDRATE, ser0_rec, extern) |
-					IO_STATE(R_ALT_SER_BAUDRATE, ser0_tr, extern);
-				DBAUD(printk("using external baudrate: %lu\n", CONFIG_ETRAX_EXTERN_PB6CLK_FREQ/8));
-				info->baud = CONFIG_ETRAX_EXTERN_PB6CLK_FREQ/8;
-			}
-#endif
 		else
 		{
 			/* Bad baudbase, we don't support using timer0