gpio: move GPIOD flags outside #ifdef

The GPIOD flags are defined inside the #ifdef CONFIG_GPIOLIB
switch, making the gpiolib stubs fail if these flags are used
by a consumer. This is not correct: the stubs should compile
fine without GPIOLIB.
Reported-by: NUlf Hansson <ulf.hansson@linaro.org>
Reviewed-by: NAlexandre Courbot <acourbot@nvidia.com>
Signed-off-by: NLinus Walleij <linus.walleij@linaro.org>

include/linux/gpio/consumer.h

@@ -16,8 +16,6 @@ struct device;
  */
 struct gpio_desc;
 
-#ifdef CONFIG_GPIOLIB
-
 #define GPIOD_FLAGS_BIT_DIR_SET		BIT(0)
 #define GPIOD_FLAGS_BIT_DIR_OUT		BIT(1)
 #define GPIOD_FLAGS_BIT_DIR_VAL		BIT(2)
@@ -34,6 +32,8 @@ enum gpiod_flags {
 			  GPIOD_FLAGS_BIT_DIR_VAL,
 };
 
+#ifdef CONFIG_GPIOLIB
+
 /* Acquire and dispose GPIOs */
 struct gpio_desc *__must_check __gpiod_get(struct device *dev,
 					 const char *con_id,