[POWERPC] Fix PCI IRQ fallback code to not map IRQ 0

The PCI IRQ code has a fallback when the device-tree parsing fails, that
tries to map the interrupt indicated by PCI_INTERRUPT_LINE if the firmware
set something in there. This is a bit fragile but has proven useful in some
cases so far. However, it's causing us to incorrectly try to map interrupt 0
on various setups, so let's prevent that case, as none of the cases where
the fallback is legit should have an IRQ 0.
Signed-off-by: NBenjamin Herrenschmidt <benh@kernel.crashing.org>
Signed-off-by: NPaul Mackerras <paulus@samba.org>

arch/powerpc/kernel/pci-common.c

@@ -225,10 +225,11 @@ int pci_read_irq_line(struct pci_dev *pci_dev)
 		if (pin == 0)
 			return -1;
 		if (pci_read_config_byte(pci_dev, PCI_INTERRUPT_LINE, &line) ||
-		    line == 0xff) {
+		    line == 0xff || line == 0) {
 			return -1;
 		}
-		DBG(" -> no map ! Using irq line %d from PCI config\n", line);
+		DBG(" -> no map ! Using line %d (pin %d) from PCI config\n",
+		    line, pin);
 
 		virq = irq_create_mapping(NULL, line);
 		if (virq != NO_IRQ)