提交 4f2ebe00 编写于 作者: L Lucas Stach 提交者: Bjorn Helgaas

PCI: designware: Parse bus-range property from devicetree

This allows to explicitly specify the covered bus numbers in the
devicetree, which will come in handy once we see a SoC with more than one
PCIe host controller instance.

Previously the driver relied on the behavior of pci_scan_root_bus() to fill
in a range of 0x00-0xff if no valid range was found.  We fall back to the
same range if no valid DT entry was found to keep backwards compatibility,
but now do it explicitly.

[bhelgaas: use %pR in error message to avoid duplication]
Signed-off-by: NLucas Stach <l.stach@pengutronix.de>
Signed-off-by: NBjorn Helgaas <bhelgaas@google.com>
Reviewed-by: NPratyush Anand <pratyush.anand@st.com>
Acked-by: NMohit Kumar <mohit.kumar@st.com>
上级 b14a3d17
......@@ -23,3 +23,6 @@ Required properties:
Optional properties:
- reset-gpio: gpio pin number of power good signal
- bus-range: PCI bus numbers covered (it is recommended for new devicetrees to
specify this property, to keep backwards compatibility a range of 0x00-0xff
is assumed if not present)
......@@ -500,6 +500,16 @@ int __init dw_pcie_host_init(struct pcie_port *pp)
}
}
ret = of_pci_parse_bus_range(np, &pp->busn);
if (ret < 0) {
pp->busn.name = np->name;
pp->busn.start = 0;
pp->busn.end = 0xff;
pp->busn.flags = IORESOURCE_BUS;
dev_dbg(pp->dev, "failed to parse bus-range property: %d, using default %pR\n",
ret, &pp->busn);
}
if (!pp->dbi_base) {
pp->dbi_base = devm_ioremap(pp->dev, pp->cfg.start,
resource_size(&pp->cfg));
......@@ -794,6 +804,7 @@ static int dw_pcie_setup(int nr, struct pci_sys_data *sys)
sys->mem_offset = pp->mem.start - pp->config.mem_bus_addr;
pci_add_resource_offset(&sys->resources, &pp->mem, sys->mem_offset);
pci_add_resource(&sys->resources, &pp->busn);
return 1;
}
......
......@@ -48,6 +48,7 @@ struct pcie_port {
struct resource cfg;
struct resource io;
struct resource mem;
struct resource busn;
struct pcie_port_info config;
int irq;
u32 lanes;
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册