i40e: eeprom integrity check on load and empr

The driver needs to verify the eeprom checksum and firmware crc status bits,
and shutdown the driver if they fail. This code stops the processing of traffic,
but doesn't kill the PF netdev so that the NVMUpdate process should still have a
chance at fixing the image. The eeprom is checked on driver load and after an
EMP reset, the latter of which should be generated after an NVMUpdate.

Change-ID: I34deef21d2e16bf5a43c603cf8af27e6a29dc9d2
Signed-off-by: NShannon Nelson <shannon.nelson@intel.com>
Signed-off-by: NCatherine Sullivan <catherine.sullivan@intel.com>
Tested-by: NKavindya Deegala <kavindya.s.deegala@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/i40e/i40e.h

@@ -136,6 +136,7 @@ enum i40e_state_t {
 	__I40E_EMP_RESET_REQUESTED,
 	__I40E_FILTER_OVERFLOW_PROMISC,
 	__I40E_SUSPENDED,
+	__I40E_BAD_EEPROM,
 };
 
 enum i40e_interrupt_policy {

drivers/net/ethernet/intel/i40e/i40e_main.c

@@ -26,6 +26,7 @@
 
 /* Local includes */
 #include "i40e.h"
+#include "i40e_diag.h"
 #ifdef CONFIG_I40E_VXLAN
 #include <net/vxlan.h>
 #endif
@@ -2877,12 +2878,14 @@ static irqreturn_t i40e_intr(int irq, void *data)
 		val = rd32(hw, I40E_GLGEN_RSTAT);
 		val = (val & I40E_GLGEN_RSTAT_RESET_TYPE_MASK)
 		       >> I40E_GLGEN_RSTAT_RESET_TYPE_SHIFT;
-		if (val == I40E_RESET_CORER)
+		if (val == I40E_RESET_CORER) {
 			pf->corer_count++;
-		else if (val == I40E_RESET_GLOBR)
+		} else if (val == I40E_RESET_GLOBR) {
 			pf->globr_count++;
-		else if (val == I40E_RESET_EMPR)
+		} else if (val == I40E_RESET_EMPR) {
 			pf->empr_count++;
+			set_bit(__I40E_EMP_RESET_REQUESTED, &pf->state);
+		}
 	}
 
 	if (icr0 & I40E_PFINT_ICR0_HMC_ERR_MASK) {
@@ -4257,8 +4260,9 @@ static int i40e_open(struct net_device *netdev)
 	struct i40e_pf *pf = vsi->back;
 	int err;
 
-	/* disallow open during test */
-	if (test_bit(__I40E_TESTING, &pf->state))
+	/* disallow open during test or if eeprom is broken */
+	if (test_bit(__I40E_TESTING, &pf->state) ||
+	    test_bit(__I40E_BAD_EEPROM, &pf->state))
 		return -EBUSY;
 
 	netif_carrier_off(netdev);
@@ -5077,6 +5081,31 @@ static void i40e_clean_adminq_subtask(struct i40e_pf *pf)
 	kfree(event.msg_buf);
 }
 
+/**
+ * i40e_verify_eeprom - make sure eeprom is good to use
+ * @pf: board private structure
+ **/
+static void i40e_verify_eeprom(struct i40e_pf *pf)
+{
+	int err;
+
+	err = i40e_diag_eeprom_test(&pf->hw);
+	if (err) {
+		/* retry in case of garbage read */
+		err = i40e_diag_eeprom_test(&pf->hw);
+		if (err) {
+			dev_info(&pf->pdev->dev, "eeprom check failed (%d), Tx/Rx traffic disabled\n",
+				 err);
+			set_bit(__I40E_BAD_EEPROM, &pf->state);
+		}
+	}
+
+	if (!err && test_bit(__I40E_BAD_EEPROM, &pf->state)) {
+		dev_info(&pf->pdev->dev, "eeprom check passed, Tx/Rx traffic enabled\n");
+		clear_bit(__I40E_BAD_EEPROM, &pf->state);
+	}
+}
+
 /**
  * i40e_reconstitute_veb - rebuild the VEB and anything connected to it
  * @veb: pointer to the VEB instance
@@ -5386,6 +5415,12 @@ static void i40e_reset_and_rebuild(struct i40e_pf *pf, bool reinit)
 		goto end_core_reset;
 	}
 
+	/* re-verify the eeprom if we just had an EMP reset */
+	if (test_bit(__I40E_EMP_RESET_REQUESTED, &pf->state)) {
+		clear_bit(__I40E_EMP_RESET_REQUESTED, &pf->state);
+		i40e_verify_eeprom(pf);
+	}
+
 	ret = i40e_get_capabilities(pf);
 	if (ret) {
 		dev_info(&pf->pdev->dev, "i40e_get_capabilities failed, %d\n",
@@ -8157,6 +8192,8 @@ static int i40e_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
 		goto err_pf_reset;
 	}
 
+	i40e_verify_eeprom(pf);
+
 	i40e_clear_pxe_mode(hw);
 	err = i40e_get_capabilities(pf);
 	if (err)
@@ -8258,7 +8295,8 @@ static int i40e_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
 
 	/* prep for VF support */
 	if ((pf->flags & I40E_FLAG_SRIOV_ENABLED) &&
-	    (pf->flags & I40E_FLAG_MSIX_ENABLED)) {
+	    (pf->flags & I40E_FLAG_MSIX_ENABLED) &&
+	    !test_bit(__I40E_BAD_EEPROM, &pf->state)) {
 		u32 val;
 
 		/* disable link interrupts for VFs */