i2c-davinci: Fix race when setting up for TX

When setting up to transmit, a race exists between the ISR and
i2c_davinci_xfer_msg() trying to load the first byte and adjust counters.
This is mostly visible for transmits > 1 byte long.

The hardware starts sending immediately that MDR is loaded. IMR trickery
doesn't work because if we start sending, finish the first byte and an
XRDY event occurs before we load IMR to unmask it, we never get an
interrupt, and we timeout.

Move the MDR load after DXR,IMR loads to avoid this race without locking.

Tested on DM355 connected to Techwell TW2836 and Wolfson WM8985
Signed-off-by: NJon Povey <jon.povey@racelogic.co.uk>
Signed-off-by: NBen Dooks <ben-linux@fluff.org>

drivers/i2c/busses/i2c-davinci.c

@@ -357,9 +357,6 @@ i2c_davinci_xfer_msg(struct i2c_adapter *adap, struct i2c_msg *msg, int stop)
 
 	dev->terminate = 0;
 
-	/* write the data into mode register */
-	davinci_i2c_write_reg(dev, DAVINCI_I2C_MDR_REG, flag);
-
 	/*
 	 * First byte should be set here, not after interrupt,
 	 * because transmit-data-ready interrupt can come before
@@ -371,6 +368,9 @@ i2c_davinci_xfer_msg(struct i2c_adapter *adap, struct i2c_msg *msg, int stop)
 		dev->buf_len--;
 	}
 
+	/* write the data into mode register; start transmitting */
+	davinci_i2c_write_reg(dev, DAVINCI_I2C_MDR_REG, flag);
+
 	r = wait_for_completion_interruptible_timeout(&dev->cmd_complete,
 						      dev->adapter.timeout);
 	if (r == 0) {