bnx2x: Initialize cnic status block during chip reset

When the device is reset during MTU change, ring size change, or self
test, etc, the cnic status block needs to be properly initialized if
cnic is registered.
Signed-off-by: NMichael Chan <mchan@broadcom.com>
Signed-off-by: NEilon Greenstein <eilong@broadcom.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>

drivers/net/bnx2x_main.c

@@ -7593,6 +7593,8 @@ static int bnx2x_nic_load(struct bnx2x *bp, int load_mode)
 		if (bp->cnic_eth_dev.drv_state & CNIC_DRV_STATE_REGD) {
 			bnx2x_set_iscsi_eth_mac_addr(bp, 1);
 			bp->cnic_flags |= BNX2X_CNIC_FLAG_MAC_SET;
+			bnx2x_init_sb(bp, bp->cnic_sb, bp->cnic_sb_mapping,
+				      CNIC_SB_ID(bp));
 		}
 		mutex_unlock(&bp->cnic_mutex);
 #endif