agp: efficeon-agp: do not use PCI resources before pci_enable_device()

IRQ and resource[] may not have correct values until
after PCI hotplug setup occurs at pci_enable_device() time.

The semantic match that finds this problem is as follows:

// <smpl>
@@
identifier x;
identifier request ~= "pci_request.*|pci_resource.*";
@@

(
* x->irq
|
* x->resource
|
* request(x, ...)
)
 ...
*pci_enable_device(x)
// </smpl>
Signed-off-by: NKulikov Vasiliy <segooon@gmail.com>
Signed-off-by: NDave Airlie <airlied@redhat.com>

drivers/char/agp/efficeon-agp.c

@@ -371,6 +371,17 @@ static int __devinit agp_efficeon_probe(struct pci_dev *pdev,
 	bridge->dev = pdev;
 	bridge->capndx = cap_ptr;
 
+	/*
+	* If the device has not been properly setup, the following will catch
+	* the problem and should stop the system from crashing.
+	* 20030610 - hamish@zot.org
+	*/
+	if (pci_enable_device(pdev)) {
+		printk(KERN_ERR PFX "Unable to Enable PCI device\n");
+		agp_put_bridge(bridge);
+		return -ENODEV;
+	}
+
 	/*
 	* The following fixes the case where the BIOS has "forgotten" to
 	* provide an address range for the GART.
@@ -385,17 +396,6 @@ static int __devinit agp_efficeon_probe(struct pci_dev *pdev,
 		}
 	}
 
-	/*
-	* If the device has not been properly setup, the following will catch
-	* the problem and should stop the system from crashing.
-	* 20030610 - hamish@zot.org
-	*/
-	if (pci_enable_device(pdev)) {
-		printk(KERN_ERR PFX "Unable to Enable PCI device\n");
-		agp_put_bridge(bridge);
-		return -ENODEV;
-	}
-
 	/* Fill in the mode register */
 	if (cap_ptr) {
 		pci_read_config_dword(pdev,