IB/qib: Set default LE2 value for active cables to 0

For active and far-EQ cables use an LE2 value of 0 for improved SI.
Signed-off-by: NMitko Haralanov <mitko@qlogic.com>
Signed-off-by: NMike Marciniszyn <mike.marciniszyn@qlogic.com>
Signed-off-by: NRoland Dreier <roland@purestorage.com>

drivers/infiniband/hw/qib/qib_iba7322.c

@@ -5582,9 +5582,16 @@ static void qsfp_7322_event(struct work_struct *work)
 	 * even on failure to read cable information.  We don't
 	 * get here for QME, so IS_QME check not needed here.
 	 */
-	le2 = (!ret && qd->cache.atten[1] >= qib_long_atten &&
-	       !ppd->dd->cspec->r1 && QSFP_IS_CU(qd->cache.tech)) ?
-		LE2_5m : LE2_DEFAULT;
+	if (!ret && !ppd->dd->cspec->r1) {
+		if (QSFP_IS_ACTIVE_FAR(qd->cache.tech))
+			le2 = LE2_QME;
+		else if (qd->cache.atten[1] >= qib_long_atten &&
+			 QSFP_IS_CU(qd->cache.tech))
+			le2 = LE2_5m;
+		else
+			le2 = LE2_DEFAULT;
+	} else
+		le2 = LE2_DEFAULT;
 	ibsd_wr_allchans(ppd, 13, (le2 << 7), BMASK(9, 7));
 	init_txdds_table(ppd, 0);
 }

drivers/infiniband/hw/qib/qib_qsfp.h

@@ -79,6 +79,8 @@
 extern const char *const qib_qsfp_devtech[16];
 /* Active Equalization includes fiber, copper full EQ, and copper near Eq */
 #define QSFP_IS_ACTIVE(tech) ((0xA2FF >> ((tech) >> 4)) & 1)
+/* Active Equalization includes fiber, copper full EQ, and copper far Eq */
+#define QSFP_IS_ACTIVE_FAR(tech) ((0x32FF >> ((tech) >> 4)) & 1)
 /* Attenuation should be valid for copper other than full/near Eq */
 #define QSFP_HAS_ATTEN(tech) ((0x4D00 >> ((tech) >> 4)) & 1)
 /* Length is only valid if technology is "copper" */