提交 45b79a29 编写于 作者: A Adam Buchbinder 提交者: Jiri Kosina

ia64: Fix misspellings in comments.

Signed-off-by: NAdam Buchbinder <adam.buchbinder@gmail.com>
Signed-off-by: NJiri Kosina <jkosina@suse.cz>
上级 238034e3
......@@ -131,7 +131,7 @@ struct ioc3 {
#define SSCR_PAUSE_STATE 0x40000000 /* set when PAUSE takes effect*/
#define SSCR_RESET 0x80000000 /* reset DMA channels */
/* all producer/comsumer pointers are the same bitfield */
/* all producer/consumer pointers are the same bitfield */
#define PROD_CONS_PTR_4K 0x00000ff8 /* for 4K buffers */
#define PROD_CONS_PTR_1K 0x000003f8 /* for 1K buffers */
#define PROD_CONS_PTR_OFF 3
......
......@@ -1385,7 +1385,7 @@ typedef union ii_ibcr_u {
* respones are captured until IXSS[VALID] is cleared by setting the *
* appropriate bit in IECLR. Every time a spurious read response is *
* detected, the SPUR_RD bit of the PRB corresponding to the incoming *
* message's SIDN field is set. This always happens, regarless of *
* message's SIDN field is set. This always happens, regardless of *
* whether a header is captured. The programmer should check *
* IXSM[SIDN] to determine which widget sent the spurious response, *
* because there may be more than one SPUR_RD bit set in the PRB *
......@@ -2997,7 +2997,7 @@ typedef union ii_ippr_u {
/*
* Values for field imsgtype
*/
#define IIO_ICRB_IMSGT_XTALK 0 /* Incoming Meessage from Xtalk */
#define IIO_ICRB_IMSGT_XTALK 0 /* Incoming message from Xtalk */
#define IIO_ICRB_IMSGT_BTE 1 /* Incoming message from BTE */
#define IIO_ICRB_IMSGT_SN1NET 2 /* Incoming message from SN1 net */
#define IIO_ICRB_IMSGT_CRB 3 /* Incoming message from CRB ??? */
......
......@@ -966,7 +966,7 @@ efi_uart_console_only(void)
/*
* Look for the first granule aligned memory descriptor memory
* that is big enough to hold EFI memory map. Make sure this
* descriptor is atleast granule sized so it does not get trimmed
* descriptor is at least granule sized so it does not get trimmed
*/
struct kern_memdesc *
find_memmap_space (void)
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册