mfd: omap-usb-host: Remove PHY reset handling code

PHY reset GPIO handling will be done in the PHY driver
Signed-off-by: NRoger Quadros <rogerq@ti.com>
Acked-by: NFelipe Balbi <balbi@ti.com>
Acked-by: NSamuel Ortiz <sameo@linux.intel.com>
Signed-off-by: NSamuel Ortiz <sameo@linux.intel.com>

drivers/mfd/omap-usb-host.c

@@ -430,24 +430,10 @@ static unsigned omap_usbhs_rev2_hostconfig(struct usbhs_hcd_omap *omap,
 static void omap_usbhs_init(struct device *dev)
 {
 	struct usbhs_hcd_omap		*omap = dev_get_drvdata(dev);
-	struct usbhs_omap_platform_data	*pdata = omap->pdata;
 	unsigned			reg;
 
 	dev_dbg(dev, "starting TI HSUSB Controller\n");
 
-	if (pdata->phy_reset) {
-		if (gpio_is_valid(pdata->reset_gpio_port[0]))
-			devm_gpio_request_one(dev, pdata->reset_gpio_port[0],
-					 GPIOF_OUT_INIT_LOW, "USB1 PHY reset");
-
-		if (gpio_is_valid(pdata->reset_gpio_port[1]))
-			devm_gpio_request_one(dev, pdata->reset_gpio_port[1],
-					 GPIOF_OUT_INIT_LOW, "USB2 PHY reset");
-
-		/* Hold the PHY in RESET for enough time till DIR is high */
-		udelay(10);
-	}
-
 	pm_runtime_get_sync(dev);
 
 	reg = usbhs_read(omap->uhh_base, OMAP_UHH_HOSTCONFIG);
@@ -476,20 +462,6 @@ static void omap_usbhs_init(struct device *dev)
 	dev_dbg(dev, "UHH setup done, uhh_hostconfig=%x\n", reg);
 
 	pm_runtime_put_sync(dev);
-	if (pdata->phy_reset) {
-		/* Hold the PHY in RESET for enough time till
-		 * PHY is settled and ready
-		 */
-		udelay(10);
-
-		if (gpio_is_valid(pdata->reset_gpio_port[0]))
-			gpio_set_value_cansleep
-				(pdata->reset_gpio_port[0], 1);
-
-		if (gpio_is_valid(pdata->reset_gpio_port[1]))
-			gpio_set_value_cansleep
-				(pdata->reset_gpio_port[1], 1);
-	}
 }
 
 /**