提交 3ff4b573 编写于 作者: R Rasmus Villemoes 提交者: Felipe Balbi

usb: musb: convert printk to pr_*

This file already uses pr_debug in a few places; this converts the
remaining printks.
Signed-off-by: NRasmus Villemoes <linux@rasmusvillemoes.dk>
Signed-off-by: NFelipe Balbi <balbi@ti.com>
上级 29539019
......@@ -1360,8 +1360,7 @@ static int ep_config_from_table(struct musb *musb)
break;
}
printk(KERN_DEBUG "%s: setup fifo_mode %d\n",
musb_driver_name, fifo_mode);
pr_debug("%s: setup fifo_mode %d\n", musb_driver_name, fifo_mode);
done:
......@@ -1390,7 +1389,7 @@ static int ep_config_from_table(struct musb *musb)
musb->nr_endpoints = max(epn, musb->nr_endpoints);
}
printk(KERN_DEBUG "%s: %d/%d max ep, %d/%d memory\n",
pr_debug("%s: %d/%d max ep, %d/%d memory\n",
musb_driver_name,
n + 1, musb->config->num_eps * 2 - 1,
offset, (1 << (musb->config->ram_bits + 2)));
......@@ -1491,8 +1490,7 @@ static int musb_core_init(u16 musb_type, struct musb *musb)
if (reg & MUSB_CONFIGDATA_SOFTCONE)
strcat(aInfo, ", SoftConn");
printk(KERN_DEBUG "%s: ConfigData=0x%02x (%s)\n",
musb_driver_name, reg, aInfo);
pr_debug("%s: ConfigData=0x%02x (%s)\n", musb_driver_name, reg, aInfo);
aDate[0] = 0;
if (MUSB_CONTROLLER_MHDRC == musb_type) {
......@@ -1502,9 +1500,8 @@ static int musb_core_init(u16 musb_type, struct musb *musb)
musb->is_multipoint = 0;
type = "";
#ifndef CONFIG_USB_OTG_BLACKLIST_HUB
printk(KERN_ERR
"%s: kernel must blacklist external hubs\n",
musb_driver_name);
pr_err("%s: kernel must blacklist external hubs\n",
musb_driver_name);
#endif
}
......@@ -1513,8 +1510,8 @@ static int musb_core_init(u16 musb_type, struct musb *musb)
snprintf(aRevision, 32, "%d.%d%s", MUSB_HWVERS_MAJOR(musb->hwvers),
MUSB_HWVERS_MINOR(musb->hwvers),
(musb->hwvers & MUSB_HWVERS_RC) ? "RC" : "");
printk(KERN_DEBUG "%s: %sHDRC RTL version %s %s\n",
musb_driver_name, type, aRevision, aDate);
pr_debug("%s: %sHDRC RTL version %s %s\n",
musb_driver_name, type, aRevision, aDate);
/* configure ep0 */
musb_configure_ep0(musb);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册