ARM: dts: imx6: phyFLEX: set nodes in alphabetical order

The gmpi and fec node were not in alphabatical order.
Signed-off-by: NChristian Hemp <c.hemp@phytec.de>
Signed-off-by: NShawn Guo <shawn.guo@linaro.org>

arch/arm/boot/dts/imx6qdl-phytec-pfla02.dtsi

@@ -78,6 +78,22 @@
 	};
 };
 
+&fec {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pinctrl_enet>;
+	phy-mode = "rgmii";
+	phy-reset-gpios = <&gpio3 23 GPIO_ACTIVE_LOW>;
+	phy-supply = <&vdd_eth_io_reg>;
+	status = "disabled";
+};
+
+&gpmi {
+	pinctrl-names = "default";
+	pinctrl-0 = <&pinctrl_gpmi_nand>;
+	nand-on-flash-bbt;
+	status = "disabled";
+};
+
 &i2c1 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_i2c1>;
@@ -337,22 +353,6 @@
 	};
 };
 
-&fec {
-	pinctrl-names = "default";
-	pinctrl-0 = <&pinctrl_enet>;
-	phy-mode = "rgmii";
-	phy-reset-gpios = <&gpio3 23 GPIO_ACTIVE_LOW>;
-	phy-supply = <&vdd_eth_io_reg>;
-	status = "disabled";
-};
-
-&gpmi {
-	pinctrl-names = "default";
-	pinctrl-0 = <&pinctrl_gpmi_nand>;
-	nand-on-flash-bbt;
-	status = "disabled";
-};
-
 &uart3 {
 	pinctrl-names = "default";
 	pinctrl-0 = <&pinctrl_uart3>;