Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/drzeus/mmc

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/drzeus/mmc:
  sdhci-of: Fix the wrong accessor to HOSTVER register
  mvsdio: fix config failure with some high speed SDHC cards
  mvsdio: ignore high speed timing requests from the core
  mmc/omap: Use disable_irq_nosync() from within irq handlers.
  sdhci-of: Add fsl,esdhc as a valid compatible to bind against
  mvsdio: allow automatic loading when modular
  mxcmmc: Fix missing return value checking in DMA setup code.
  mxcmmc : Reset the SDHC hardware if software timeout occurs.
  omap_hsmmc: Trivial fix for a typo in comment
  mxcmmc: decrease minimum frequency to make MMC cards work

drivers/mmc/host/mvsdio.c

@@ -64,6 +64,31 @@ static int mvsd_setup_data(struct mvsd_host *host, struct mmc_data *data)
 	unsigned int tmout;
 	int tmout_index;
 
+	/*
+	 * Hardware weirdness.  The FIFO_EMPTY bit of the HW_STATE
+	 * register is sometimes not set before a while when some
+	 * "unusual" data block sizes are used (such as with the SWITCH
+	 * command), even despite the fact that the XFER_DONE interrupt
+	 * was raised.  And if another data transfer starts before
+	 * this bit comes to good sense (which eventually happens by
+	 * itself) then the new transfer simply fails with a timeout.
+	 */
+	if (!(mvsd_read(MVSD_HW_STATE) & (1 << 13))) {
+		unsigned long t = jiffies + HZ;
+		unsigned int hw_state,  count = 0;
+		do {
+			if (time_after(jiffies, t)) {
+				dev_warn(host->dev, "FIFO_EMPTY bit missing\n");
+				break;
+			}
+			hw_state = mvsd_read(MVSD_HW_STATE);
+			count++;
+		} while (!(hw_state & (1 << 13)));
+		dev_dbg(host->dev, "*** wait for FIFO_EMPTY bit "
+				   "(hw=0x%04x, count=%d, jiffies=%ld)\n",
+				   hw_state, count, jiffies - (t - HZ));
+	}
+
 	/* If timeout=0 then maximum timeout index is used. */
 	tmout = DIV_ROUND_UP(data->timeout_ns, host->ns_per_clk);
 	tmout += data->timeout_clks;
@@ -620,9 +645,18 @@ static void mvsd_set_ios(struct mmc_host *mmc, struct mmc_ios *ios)
 	if (ios->bus_width == MMC_BUS_WIDTH_4)
 		ctrl_reg |= MVSD_HOST_CTRL_DATA_WIDTH_4_BITS;
 
+	/*
+	 * The HI_SPEED_EN bit is causing trouble with many (but not all)
+	 * high speed SD, SDHC and SDIO cards.  Not enabling that bit
+	 * makes all cards work.  So let's just ignore that bit for now
+	 * and revisit this issue if problems for not enabling this bit
+	 * are ever reported.
+	 */
+#if 0
 	if (ios->timing == MMC_TIMING_MMC_HS ||
 	    ios->timing == MMC_TIMING_SD_HS)
 		ctrl_reg |= MVSD_HOST_CTRL_HI_SPEED_EN;
+#endif
 
 	host->ctrl = ctrl_reg;
 	mvsd_write(MVSD_HOST_CTRL, ctrl_reg);
@@ -882,3 +916,4 @@ module_param(nodma, int, 0);
 MODULE_AUTHOR("Maen Suleiman, Nicolas Pitre");
 MODULE_DESCRIPTION("Marvell MMC,SD,SDIO Host Controller driver");
 MODULE_LICENSE("GPL");
+MODULE_ALIAS("platform:mvsdio");

drivers/mmc/host/mxcmmc.c

@@ -140,6 +140,8 @@ struct mxcmci_host {
 	struct work_struct	datawork;
 };
 
+static void mxcmci_set_clk_rate(struct mxcmci_host *host, unsigned int clk_ios);
+
 static inline int mxcmci_use_dma(struct mxcmci_host *host)
 {
 	return host->do_dma;
@@ -160,7 +162,7 @@ static void mxcmci_softreset(struct mxcmci_host *host)
 	writew(0xff, host->base + MMC_REG_RES_TO);
 }
 
-static void mxcmci_setup_data(struct mxcmci_host *host, struct mmc_data *data)
+static int mxcmci_setup_data(struct mxcmci_host *host, struct mmc_data *data)
 {
 	unsigned int nob = data->blocks;
 	unsigned int blksz = data->blksz;
@@ -168,6 +170,7 @@ static void mxcmci_setup_data(struct mxcmci_host *host, struct mmc_data *data)
 #ifdef HAS_DMA
 	struct scatterlist *sg;
 	int i;
+	int ret;
 #endif
 	if (data->flags & MMC_DATA_STREAM)
 		nob = 0xffff;
@@ -183,7 +186,7 @@ static void mxcmci_setup_data(struct mxcmci_host *host, struct mmc_data *data)
 	for_each_sg(data->sg, sg, data->sg_len, i) {
 		if (sg->offset & 3 || sg->length & 3) {
 			host->do_dma = 0;
-			return;
+			return 0;
 		}
 	}
 
@@ -192,23 +195,30 @@ static void mxcmci_setup_data(struct mxcmci_host *host, struct mmc_data *data)
 		host->dma_nents = dma_map_sg(mmc_dev(host->mmc), data->sg,
 					     data->sg_len,  host->dma_dir);
 
-		imx_dma_setup_sg(host->dma, data->sg, host->dma_nents, datasize,
-				 host->res->start + MMC_REG_BUFFER_ACCESS,
-				 DMA_MODE_READ);
+		ret = imx_dma_setup_sg(host->dma, data->sg, host->dma_nents,
+				datasize,
+				host->res->start + MMC_REG_BUFFER_ACCESS,
+				DMA_MODE_READ);
 	} else {
 		host->dma_dir = DMA_TO_DEVICE;
 		host->dma_nents = dma_map_sg(mmc_dev(host->mmc), data->sg,
 					     data->sg_len,  host->dma_dir);
 
-		imx_dma_setup_sg(host->dma, data->sg, host->dma_nents, datasize,
-				 host->res->start + MMC_REG_BUFFER_ACCESS,
-				 DMA_MODE_WRITE);
+		ret = imx_dma_setup_sg(host->dma, data->sg, host->dma_nents,
+				datasize,
+				host->res->start + MMC_REG_BUFFER_ACCESS,
+				DMA_MODE_WRITE);
 	}
 
+	if (ret) {
+		dev_err(mmc_dev(host->mmc), "failed to setup DMA : %d\n", ret);
+		return ret;
+	}
 	wmb();
 
 	imx_dma_enable(host->dma);
 #endif /* HAS_DMA */
+	return 0;
 }
 
 static int mxcmci_start_cmd(struct mxcmci_host *host, struct mmc_command *cmd,
@@ -345,8 +355,11 @@ static int mxcmci_poll_status(struct mxcmci_host *host, u32 mask)
 		stat = readl(host->base + MMC_REG_STATUS);
 		if (stat & STATUS_ERR_MASK)
 			return stat;
-		if (time_after(jiffies, timeout))
+		if (time_after(jiffies, timeout)) {
+			mxcmci_softreset(host);
+			mxcmci_set_clk_rate(host, host->clock);
 			return STATUS_TIME_OUT_READ;
+		}
 		if (stat & mask)
 			return 0;
 		cpu_relax();
@@ -531,6 +544,7 @@ static void mxcmci_request(struct mmc_host *mmc, struct mmc_request *req)
 {
 	struct mxcmci_host *host = mmc_priv(mmc);
 	unsigned int cmdat = host->cmdat;
+	int error;
 
 	WARN_ON(host->req != NULL);
 
@@ -540,7 +554,12 @@ static void mxcmci_request(struct mmc_host *mmc, struct mmc_request *req)
 	host->do_dma = 1;
 #endif
 	if (req->data) {
-		mxcmci_setup_data(host, req->data);
+		error = mxcmci_setup_data(host, req->data);
+		if (error) {
+			req->cmd->error = error;
+			goto out;
+		}
+
 
 		cmdat |= CMD_DAT_CONT_DATA_ENABLE;
 
@@ -548,7 +567,9 @@ static void mxcmci_request(struct mmc_host *mmc, struct mmc_request *req)
 			cmdat |= CMD_DAT_CONT_WRITE;
 	}
 
-	if (mxcmci_start_cmd(host, req->cmd, cmdat))
+	error = mxcmci_start_cmd(host, req->cmd, cmdat);
+out:
+	if (error)
 		mxcmci_finish_request(host, req);
 }
 
@@ -724,7 +745,9 @@ static int mxcmci_probe(struct platform_device *pdev)
 		goto out_clk_put;
 	}
 
-	mmc->f_min = clk_get_rate(host->clk) >> 7;
+	mmc->f_min = clk_get_rate(host->clk) >> 16;
+	if (mmc->f_min < 400000)
+		mmc->f_min = 400000;
 	mmc->f_max = clk_get_rate(host->clk) >> 1;
 
 	/* recommended in data sheet */

drivers/mmc/host/omap.c

@@ -822,7 +822,7 @@ static irqreturn_t mmc_omap_irq(int irq, void *dev_id)
 		del_timer(&host->cmd_abort_timer);
 		host->abort = 1;
 		OMAP_MMC_WRITE(host, IE, 0);
-		disable_irq(host->irq);
+		disable_irq_nosync(host->irq);
 		schedule_work(&host->cmd_abort_work);
 		return IRQ_HANDLED;
 	}

drivers/mmc/host/omap_hsmmc.c

@@ -680,7 +680,7 @@ static void mmc_omap_dma_cb(int lch, u16 ch_status, void *data)
 	host->dma_ch = -1;
 	/*
 	 * DMA Callback: run in interrupt context.
-	 * mutex_unlock will through a kernel warning if used.
+	 * mutex_unlock will throw a kernel warning if used.
 	 */
 	up(&host->sem);
 }

drivers/mmc/host/sdhci-of.c

@@ -55,7 +55,13 @@ static u32 esdhc_readl(struct sdhci_host *host, int reg)
 
 static u16 esdhc_readw(struct sdhci_host *host, int reg)
 {
-	return in_be16(host->ioaddr + (reg ^ 0x2));
+	u16 ret;
+
+	if (unlikely(reg == SDHCI_HOST_VERSION))
+		ret = in_be16(host->ioaddr + reg);
+	else
+		ret = in_be16(host->ioaddr + (reg ^ 0x2));
+	return ret;
 }
 
 static u8 esdhc_readb(struct sdhci_host *host, int reg)
@@ -277,6 +283,7 @@ static int __devexit sdhci_of_remove(struct of_device *ofdev)
 static const struct of_device_id sdhci_of_match[] = {
 	{ .compatible = "fsl,mpc8379-esdhc", .data = &sdhci_esdhc, },
 	{ .compatible = "fsl,mpc8536-esdhc", .data = &sdhci_esdhc, },
+	{ .compatible = "fsl,esdhc", .data = &sdhci_esdhc, },
 	{ .compatible = "generic-sdhci", },
 	{},
 };