提交 3146beec 编写于 作者: G Girish K S 提交者: Mark Brown

spi: s3c64xx: Added provision for dedicated cs pin

The existing driver supports gpio based /cs signal.
For controller's that have one device per controller,
the slave device's /cs signal might be internally controlled
by the chip select bit of slave select register. They are not
externally asserted/deasserted using gpio pin.

This patch adds support for controllers with dedicated /cs pin.
if "cs-gpio" property doesnt exist in a spi dts node, the controller
would treat the /cs pin as dedicated.
Signed-off-by: NGirish K S <ks.giri@samsung.com>
Signed-off-by: NMark Brown <broonie@linaro.org>
上级 79617073
......@@ -208,6 +208,7 @@ struct s3c64xx_spi_driver_data {
struct s3c64xx_spi_port_config *port_conf;
unsigned int port_id;
unsigned long gpios[4];
bool cs_gpio;
};
static void flush_fifo(struct s3c64xx_spi_driver_data *sdd)
......@@ -570,14 +571,16 @@ static inline void enable_cs(struct s3c64xx_spi_driver_data *sdd,
if (sdd->tgl_spi != spi) { /* if last mssg on diff device */
/* Deselect the last toggled device */
cs = sdd->tgl_spi->controller_data;
gpio_set_value(cs->line,
spi->mode & SPI_CS_HIGH ? 0 : 1);
if (sdd->cs_gpio)
gpio_set_value(cs->line,
spi->mode & SPI_CS_HIGH ? 0 : 1);
}
sdd->tgl_spi = NULL;
}
cs = spi->controller_data;
gpio_set_value(cs->line, spi->mode & SPI_CS_HIGH ? 1 : 0);
if (sdd->cs_gpio)
gpio_set_value(cs->line, spi->mode & SPI_CS_HIGH ? 1 : 0);
/* Start the signals */
writel(0, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
......@@ -710,7 +713,8 @@ static inline void disable_cs(struct s3c64xx_spi_driver_data *sdd,
if (sdd->tgl_spi == spi)
sdd->tgl_spi = NULL;
gpio_set_value(cs->line, spi->mode & SPI_CS_HIGH ? 0 : 1);
if (sdd->cs_gpio)
gpio_set_value(cs->line, spi->mode & SPI_CS_HIGH ? 0 : 1);
/* Quiese the signals */
writel(S3C64XX_SPI_SLAVE_SIG_INACT, sdd->regs + S3C64XX_SPI_SLAVE_SEL);
......@@ -998,8 +1002,10 @@ static struct s3c64xx_spi_csinfo *s3c64xx_get_slave_ctrldata(
{
struct s3c64xx_spi_csinfo *cs;
struct device_node *slave_np, *data_np = NULL;
struct s3c64xx_spi_driver_data *sdd;
u32 fb_delay = 0;
sdd = spi_master_get_devdata(spi->master);
slave_np = spi->dev.of_node;
if (!slave_np) {
dev_err(&spi->dev, "device node not found\n");
......@@ -1019,7 +1025,10 @@ static struct s3c64xx_spi_csinfo *s3c64xx_get_slave_ctrldata(
return ERR_PTR(-ENOMEM);
}
cs->line = of_get_named_gpio(data_np, "cs-gpio", 0);
/* The CS line is asserted/deasserted by the gpio pin */
if (sdd->cs_gpio)
cs->line = of_get_named_gpio(data_np, "cs-gpio", 0);
if (!gpio_is_valid(cs->line)) {
dev_err(&spi->dev, "chip select gpio is not specified or invalid\n");
kfree(cs);
......@@ -1059,7 +1068,8 @@ static int s3c64xx_spi_setup(struct spi_device *spi)
return -ENODEV;
}
if (!spi_get_ctldata(spi)) {
/* Request gpio only if cs line is asserted by gpio pins */
if (sdd->cs_gpio) {
err = gpio_request_one(cs->line, GPIOF_OUT_INIT_HIGH,
dev_name(&spi->dev));
if (err) {
......@@ -1068,9 +1078,11 @@ static int s3c64xx_spi_setup(struct spi_device *spi)
cs->line, err);
goto err_gpio_req;
}
spi_set_ctldata(spi, cs);
}
if (!spi_get_ctldata(spi))
spi_set_ctldata(spi, cs);
sci = sdd->cntrlr_info;
spin_lock_irqsave(&sdd->lock, flags);
......@@ -1148,8 +1160,10 @@ static int s3c64xx_spi_setup(struct spi_device *spi)
static void s3c64xx_spi_cleanup(struct spi_device *spi)
{
struct s3c64xx_spi_csinfo *cs = spi_get_ctldata(spi);
struct s3c64xx_spi_driver_data *sdd;
if (cs) {
sdd = spi_master_get_devdata(spi->master);
if (cs && sdd->cs_gpio) {
gpio_free(cs->line);
if (spi->dev.of_node)
kfree(cs);
......@@ -1326,7 +1340,11 @@ static int s3c64xx_spi_probe(struct platform_device *pdev)
sdd->cntrlr_info = sci;
sdd->pdev = pdev;
sdd->sfr_start = mem_res->start;
sdd->cs_gpio = true;
if (pdev->dev.of_node) {
if (!of_find_property(pdev->dev.of_node, "cs-gpio", NULL))
sdd->cs_gpio = false;
ret = of_alias_get_id(pdev->dev.of_node, "spi");
if (ret < 0) {
dev_err(&pdev->dev, "failed to get alias id, errno %d\n",
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册