wl12xx: clear wl->vif on remove_interface

wl->vif should be cleared on remove_interface()
(rather than on stop()) even when only a single
vif is supported, because during vif mode change
stop() might not get called (e.g. because of
monitor interface existence)
Signed-off-by: NEliad Peller <eliad@wizery.com>
Signed-off-by: NLuciano Coelho <coelho@ti.com>

drivers/net/wireless/wl12xx/main.c

@@ -1859,7 +1859,6 @@ static void wl1271_op_stop(struct ieee80211_hw *hw)
 	wl->tx_results_count = 0;
 	wl->tx_packets_count = 0;
 	wl->time_offset = 0;
-	wl->vif = NULL;
 	wl->tx_spare_blocks = TX_HW_BLOCK_SPARE_DEFAULT;
 	wl->ap_fw_ps_map = 0;
 	wl->ap_ps_map = 0;
@@ -2211,6 +2210,8 @@ static void __wl1271_op_remove_interface(struct wl1271 *wl,
 	if (!test_and_clear_bit(WLVIF_FLAG_INITIALIZED, &wlvif->flags))
 		return;
 
+	wl->vif = NULL;
+
 	/* because of hardware recovery, we may get here twice */
 	if (wl->state != WL1271_STATE_ON)
 		return;