提交 2aff8d90 编写于 作者: R Russ Gorby 提交者: Greg Kroah-Hartman

serial: ifx6x60: probe routine needs to call spi_setup

The probe routine should call spi_setup() to configure
the SPI bus so it can properly communicate with the device.
E.g. the device operates in SPI mode 1.

Called spi_setup to configure SPI mode, max_speed_hz, and bpw
Signed-off-by: NRuss Gorby <russ.gorby@intel.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
上级 1b79b440
......@@ -67,6 +67,7 @@
#define IFX_SPI_MORE_MASK 0x10
#define IFX_SPI_MORE_BIT 12 /* bit position in u16 */
#define IFX_SPI_CTS_BIT 13 /* bit position in u16 */
#define IFX_SPI_MODE SPI_MODE_1
#define IFX_SPI_TTY_ID 0
#define IFX_SPI_TIMEOUT_SEC 2
#define IFX_SPI_HEADER_0 (-1)
......@@ -992,7 +993,15 @@ static int ifx_spi_spi_probe(struct spi_device *spi)
ifx_dev->modem = pl_data->modem_type;
ifx_dev->use_dma = pl_data->use_dma;
ifx_dev->max_hz = pl_data->max_hz;
/* initialize spi mode, etc */
spi->max_speed_hz = ifx_dev->max_hz;
spi->mode = IFX_SPI_MODE | (SPI_LOOP & spi->mode);
spi->bits_per_word = spi_bpw;
ret = spi_setup(spi);
if (ret) {
dev_err(&spi->dev, "SPI setup wasn't successful %d", ret);
return -ENODEV;
}
/* ensure SPI protocol flags are initialized to enable transfer */
ifx_dev->spi_more = 0;
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册