mmc: sdio: fix setting card data bus width as 4-bit

SDIO_CCCR_IF[1:0] in SDIO card is used for card data bus width
setting as below:

     00b: 1-bit bus
     01b: Reserved
     10b: 4-bit bus
     11b: 8-bit bus (only for embedded SDIO)

And sdio_enable_wide is for setting data bus width as 4-bit.
But currently, it first reads the register, second OR' 1b with
SDIO_CCCR_IF[1], and then writes it back.

As we can see, this is based on such assumption that the
SDIO_CCCR_IF[0] is always 0. Apparently, this is not right.
Signed-off-by: NYong Ding <yongd@marvell.com>
Acked-by: NPhilip Rakity <prakity@marvell.com>
Signed-off-by: NChris Ball <cjb@laptop.org>

drivers/mmc/core/sdio.c

@@ -218,6 +218,12 @@ static int sdio_enable_wide(struct mmc_card *card)
 	if (ret)
 		return ret;
 
+	if ((ctrl & SDIO_BUS_WIDTH_MASK) == SDIO_BUS_WIDTH_RESERVED)
+		pr_warning("%s: SDIO_CCCR_IF is invalid: 0x%02x\n",
+			   mmc_hostname(card->host), ctrl);
+
+	/* set as 4-bit bus width */
+	ctrl &= ~SDIO_BUS_WIDTH_MASK;
 	ctrl |= SDIO_BUS_WIDTH_4BIT;
 
 	ret = mmc_io_rw_direct(card, 1, 0, SDIO_CCCR_IF, ctrl, NULL);

include/linux/mmc/sdio.h

@@ -98,7 +98,9 @@
 
 #define SDIO_CCCR_IF		0x07	/* bus interface controls */
 
+#define  SDIO_BUS_WIDTH_MASK	0x03	/* data bus width setting */
 #define  SDIO_BUS_WIDTH_1BIT	0x00
+#define  SDIO_BUS_WIDTH_RESERVED 0x01
 #define  SDIO_BUS_WIDTH_4BIT	0x02
 #define  SDIO_BUS_ECSI		0x20	/* Enable continuous SPI interrupt */
 #define  SDIO_BUS_SCSI		0x40	/* Support continuous SPI interrupt */