x86, CMCI: Add proper detection of end of CMCI storms
When CMCI storm persists for a long time(at least beyond predefined threshold. It's 30 seconds for now), we can watch CMCI storm is detected immediately after it subsides. ... Dec 10 22:04:29 kernel: CMCI storm detected: switching to poll mode Dec 10 22:04:59 kernel: CMCI storm subsided: switching to interrupt mode Dec 10 22:04:59 kernel: CMCI storm detected: switching to poll mode Dec 10 22:05:29 kernel: CMCI storm subsided: switching to interrupt mode ... The problem is that our logic that determines that the storm has ended is incorrect. We announce the end, re-enable interrupts and realize that the storm is still going on, so we switch back to polling mode. Rinse, repeat. When a storm happens we disable signaling of errors via CMCI and begin polling machine check banks instead. If we find any logged errors, then we need to set a per-cpu flag so that our per-cpu tests that check whether the storm is ongoing will see that errors are still being logged independently of whether mce_notify_irq() says that the error has been fully processed. cmci_clear() is not the right tool to disable a bank. It disables the interrupt for the bank as desired, but it also clears the bit for this bank in "mce_banks_owned" so we will skip the bank when polling (so we fail to see that the storm continues because we stop looking). New cmci_storm_disable_banks() just disables the interrupt while allowing polling to continue. Reported-by: NWilliam Dauchy <wdauchy@gmail.com> Signed-off-by: NChen, Gong <gong.chen@linux.intel.com> Signed-off-by: NTony Luck <tony.luck@intel.com>
Showing
想要评论请 注册 或 登录