ARM: dts: am57xx-idk: Remove support for voltage switching for SD card

commit 88a748419b84187fd1da05637b8e5928b04a1e06 upstream.

If UHS speed modes are enabled, a compatible SD card switches down to
1.8V during enumeration. If after this a software reboot/crash takes
place and on-chip ROM tries to enumerate the SD card, the difference in
IO voltages (host @ 3.3V and card @ 1.8V) may end up damaging the card.

The fix for this is to have support for power cycling the card in
hardware (with a PORz/soft-reset line causing a power cycle of the
card). Since am571x-, am572x- and am574x-idk don't have this
capability, disable voltage switching for these boards.

The major effect of this is that the maximum supported speed
mode is now high speed(50 MHz) down from SDR104(200 MHz).

Cc: <stable@vger.kernel.org>
Signed-off-by: NFaiz Abbas <faiz_abbas@ti.com>
Signed-off-by: NTony Lindgren <tony@atomide.com>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

arch/arm/boot/dts/am57xx-idk-common.dtsi

@@ -410,6 +410,7 @@
 	vqmmc-supply = <&ldo1_reg>;
 	bus-width = <4>;
 	cd-gpios = <&gpio6 27 GPIO_ACTIVE_LOW>; /* gpio 219 */
+	no-1-8-v;
 };
 
 &mmc2 {