USB: Serial: io_ti.c: remove debug module parameter

Now that all usb-serial modules are only using dev_dbg()
the debug module parameter does not do anything at all, so
remove it to reduce any confusion if someone were to try to
use it.

CC: Johan Hovold <jhovold@gmail.com>
CC: "Eric W. Biederman" <ebiederm@xmission.com>
CC: Rusty Russell <rusty@rustcorp.com.au>
CC: Alan Stern <stern@rowland.harvard.edu>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/usb/serial/io_ti.c

@@ -201,8 +201,6 @@ static unsigned char OperationalMajorVersion;
 static unsigned char OperationalMinorVersion;
 static unsigned short OperationalBuildNumber;
 
-static bool debug;
-
 static int closing_wait = EDGE_CLOSING_WAIT;
 static bool ignore_cpu_rev;
 static int default_uart_mode;		/* RS232 */
@@ -2726,9 +2724,6 @@ MODULE_DESCRIPTION(DRIVER_DESC);
 MODULE_LICENSE("GPL");
 MODULE_FIRMWARE("edgeport/down3.bin");
 
-module_param(debug, bool, S_IRUGO | S_IWUSR);
-MODULE_PARM_DESC(debug, "Debug enabled or not");
-
 module_param(closing_wait, int, S_IRUGO | S_IWUSR);
 MODULE_PARM_DESC(closing_wait, "Maximum wait for data to drain, in .01 secs");