mmc: dw_mmc: Don't loop when handling an interrupt

There is no reason to loop when handling an interrupt. The "if" clauses
will handle all of them sequentially. This also eliminates the extra loop
we used to take with no pending interrupts and we ended up breaking out
of the while loop.
Signed-off-by: NMarkos Chandras <markos.chandras@imgtec.com>
Acked-by: NJaehoon Chung <jh80.chung@samsung.com>
Acked-by: NSeungwon Jeon <tgih.jun@samsung.com>
Signed-off-by: NChris Ball <cjb@laptop.org>

drivers/mmc/host/dw_mmc.c

@@ -1573,11 +1573,11 @@ static irqreturn_t dw_mci_interrupt(int irq, void *dev_id)
 {
 	struct dw_mci *host = dev_id;
 	u32 pending;
-	unsigned int pass_count = 0;
 	int i;
 
-	do {
-		pending = mci_readl(host, MINTSTS); /* read-only mask reg */
+	pending = mci_readl(host, MINTSTS); /* read-only mask reg */
+
+	if (pending) {
 
 		/*
 		 * DTO fix - version 2.10a and below, and only if internal DMA
@@ -1589,9 +1589,6 @@ static irqreturn_t dw_mci_interrupt(int irq, void *dev_id)
 				pending |= SDMMC_INT_DATA_OVER;
 		}
 
-		if (!pending)
-			break;
-
 		if (pending & DW_MCI_CMD_ERROR_FLAGS) {
 			mci_writel(host, RINTSTS, DW_MCI_CMD_ERROR_FLAGS);
 			host->cmd_status = pending;
@@ -1652,7 +1649,7 @@ static irqreturn_t dw_mci_interrupt(int irq, void *dev_id)
 			}
 		}
 
-	} while (pass_count++ < 5);
+	}
 
 #ifdef CONFIG_MMC_DW_IDMAC
 	/* Handle DMA interrupts */