提交 160d0fad 编写于 作者: B Ben Dooks 提交者: David S. Miller

KS8851: Fix MAC address write order

The MAC address register was being written in the wrong order, so add
a new address macro to convert mac-address byte to register address and
a ks8851_wrreg8() function to write each byte without having to worry
about any difficult byte swapping.

Fixes a bug reported by Doong, Ping of Micrel.
Signed-off-by: NBen Dooks <ben@simtec.co.uk>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
上级 57dada68
......@@ -170,6 +170,36 @@ static void ks8851_wrreg16(struct ks8851_net *ks, unsigned reg, unsigned val)
ks_err(ks, "spi_sync() failed\n");
}
/**
* ks8851_wrreg8 - write 8bit register value to chip
* @ks: The chip state
* @reg: The register address
* @val: The value to write
*
* Issue a write to put the value @val into the register specified in @reg.
*/
static void ks8851_wrreg8(struct ks8851_net *ks, unsigned reg, unsigned val)
{
struct spi_transfer *xfer = &ks->spi_xfer1;
struct spi_message *msg = &ks->spi_msg1;
__le16 txb[2];
int ret;
int bit;
bit = 1 << (reg & 3);
txb[0] = cpu_to_le16(MK_OP(bit, reg) | KS_SPIOP_WR);
txb[1] = val;
xfer->tx_buf = txb;
xfer->rx_buf = NULL;
xfer->len = 3;
ret = spi_sync(ks->spidev, msg);
if (ret < 0)
ks_err(ks, "spi_sync() failed\n");
}
/**
* ks8851_rx_1msg - select whether to use one or two messages for spi read
* @ks: The device structure
......@@ -322,13 +352,12 @@ static void ks8851_soft_reset(struct ks8851_net *ks, unsigned op)
static int ks8851_write_mac_addr(struct net_device *dev)
{
struct ks8851_net *ks = netdev_priv(dev);
u16 *mcp = (u16 *)dev->dev_addr;
int i;
mutex_lock(&ks->lock);
ks8851_wrreg16(ks, KS_MARL, mcp[0]);
ks8851_wrreg16(ks, KS_MARM, mcp[1]);
ks8851_wrreg16(ks, KS_MARH, mcp[2]);
for (i = 0; i < ETH_ALEN; i++)
ks8851_wrreg8(ks, KS_MAR(i), dev->dev_addr[i]);
mutex_unlock(&ks->lock);
......
......@@ -16,6 +16,7 @@
#define CCR_32PIN (1 << 0)
/* MAC address registers */
#define KS_MAR(_m) 0x15 - (_m)
#define KS_MARL 0x10
#define KS_MARM 0x12
#define KS_MARH 0x14
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册