OMAP: DSS2: DSI: sync when disabling a display

When the panel driver calls omapdss_dsi_display_disable() it is possible
that there are still some unsent packets in the TX fifo.

Add dsi_sync_vc() calls in the beginning of
omapdss_dsi_display_disable() to make sure the TX fifos are empty.

This allows us to remove the msleep(10) hack from panel-taal.c
Signed-off-by: NTomi Valkeinen <tomi.valkeinen@ti.com>

drivers/video/omap2/displays/panel-taal.c

@@ -1247,11 +1247,8 @@ static void taal_power_off(struct omap_dss_device *dssdev)
 	int r;
 
 	r = taal_dcs_write_0(td, DCS_DISPLAY_OFF);
-	if (!r) {
+	if (!r)
 		r = taal_sleep_in(td);
-		/* HACK: wait a bit so that the message goes through */
-		msleep(10);
-	}
 
 	if (r) {
 		dev_err(&dssdev->dev,

drivers/video/omap2/dss/dsi.c

@@ -4291,6 +4291,11 @@ void omapdss_dsi_display_disable(struct omap_dss_device *dssdev,
 
 	mutex_lock(&dsi->lock);
 
+	dsi_sync_vc(dsidev, 0);
+	dsi_sync_vc(dsidev, 1);
+	dsi_sync_vc(dsidev, 2);
+	dsi_sync_vc(dsidev, 3);
+
 	dsi_display_uninit_dispc(dssdev);
 
 	dsi_display_uninit_dsi(dssdev, disconnect_lanes, enter_ulps);