drm/tilcdc: panel: Set return value explicitly

Instead of setting an initial value for the return code, set it explicitly
on each error path. This is just a cosmetic cleanup, as preparation for the
enable GPIO support.
Tested-by: NDarren Etheridge <detheridge@ti.com>
Tested-by: NJohannes Pointner <johannes.pointner@br-automation.com>
Signed-off-by: NEzequiel Garcia <ezequiel@vanguardiasur.com.ar>
Signed-off-by: NDave Airlie <airlied@redhat.com>

drivers/gpu/drm/tilcdc/tilcdc_panel.c

@@ -346,7 +346,7 @@ static int panel_probe(struct platform_device *pdev)
 	struct panel_module *panel_mod;
 	struct tilcdc_module *mod;
 	struct pinctrl *pinctrl;
-	int ret = -EINVAL;
+	int ret;
 
 	/* bail out early if no DT data: */
 	if (!node) {
@@ -381,12 +381,14 @@ static int panel_probe(struct platform_device *pdev)
 	panel_mod->timings = of_get_display_timings(node);
 	if (!panel_mod->timings) {
 		dev_err(&pdev->dev, "could not get panel timings\n");
+		ret = -EINVAL;
 		goto fail_free;
 	}
 
 	panel_mod->info = of_get_panel_info(node);
 	if (!panel_mod->info) {
 		dev_err(&pdev->dev, "could not get panel info\n");
+		ret = -EINVAL;
 		goto fail_timings;
 	}