[SCSI] sd: Fix handling of NO_SENSE check condition

The current handling of NO_SENSE check condition is the same as
RECOVERED_ERROR, and assumes that in both cases, the I/O was fully
transferred.

We have seen cases of arrays returning with NO_SENSE (no error), but
the I/O was not completely transferred, thus residual set.  Thus,
rather than return good_bytes as the entire transfer, set good_bytes
to 0, so that the midlayer then applies the residual in calculating
the transfer, and for sd, will fail the I/O and fall into a retry
path.
Signed-off-by: NJamie Wellnitz <Jamie.Wellnitz@emulex.com>
Signed-off-by: NJames Bottomley <James.Bottomley@HansenPartnership.com>

drivers/scsi/sd.c

@@ -1054,7 +1054,6 @@ static int sd_done(struct scsi_cmnd *SCpnt)
 		good_bytes = sd_completed_bytes(SCpnt);
 		break;
 	case RECOVERED_ERROR:
-	case NO_SENSE:
 		/* Inform the user, but make sure that it's not treated
 		 * as a hard error.
 		 */
@@ -1063,6 +1062,15 @@ static int sd_done(struct scsi_cmnd *SCpnt)
 		memset(SCpnt->sense_buffer, 0, SCSI_SENSE_BUFFERSIZE);
 		good_bytes = scsi_bufflen(SCpnt);
 		break;
+	case NO_SENSE:
+		/* This indicates a false check condition, so ignore it.  An
+		 * unknown amount of data was transferred so treat it as an
+		 * error.
+		 */
+		scsi_print_sense("sd", SCpnt);
+		SCpnt->result = 0;
+		memset(SCpnt->sense_buffer, 0, SCSI_SENSE_BUFFERSIZE);
+		break;
 	case ABORTED_COMMAND:
 		if (sshdr.asc == 0x10) { /* DIF: Disk detected corruption */
 			scsi_print_result(SCpnt);