提交 0f5aac70 编写于 作者: S Stephen Hemminger 提交者: David S. Miller

sky2: 88E8059 support

Tentative support for newer Marvell hardware including
the Yukon-2 Optima chip. Do not have hatdware to test this yet,
code is based on vendor driver.
Signed-off-by: NStephen Hemminger <shemminger@vyatta.com>
Signed-off-by: NDavid S. Miller <davem@davemloft.net>
上级 877c8570
...@@ -140,6 +140,7 @@ static DEFINE_PCI_DEVICE_TABLE(sky2_id_table) = { ...@@ -140,6 +140,7 @@ static DEFINE_PCI_DEVICE_TABLE(sky2_id_table) = {
{ PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x436D) }, /* 88E8055 */ { PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x436D) }, /* 88E8055 */
{ PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4370) }, /* 88E8075 */ { PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4370) }, /* 88E8075 */
{ PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4380) }, /* 88E8057 */ { PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4380) }, /* 88E8057 */
{ PCI_DEVICE(PCI_VENDOR_ID_MARVELL, 0x4381) }, /* 88E8059 */
{ 0 } { 0 }
}; };
...@@ -603,6 +604,16 @@ static void sky2_phy_init(struct sky2_hw *hw, unsigned port) ...@@ -603,6 +604,16 @@ static void sky2_phy_init(struct sky2_hw *hw, unsigned port)
/* apply workaround for integrated resistors calibration */ /* apply workaround for integrated resistors calibration */
gm_phy_write(hw, port, PHY_MARV_PAGE_ADDR, 17); gm_phy_write(hw, port, PHY_MARV_PAGE_ADDR, 17);
gm_phy_write(hw, port, PHY_MARV_PAGE_DATA, 0x3f60); gm_phy_write(hw, port, PHY_MARV_PAGE_DATA, 0x3f60);
} else if (hw->chip_id == CHIP_ID_YUKON_OPT && hw->chip_rev == 0) {
/* apply fixes in PHY AFE */
gm_phy_write(hw, port, PHY_MARV_EXT_ADR, 0x00ff);
/* apply RDAC termination workaround */
gm_phy_write(hw, port, 24, 0x2800);
gm_phy_write(hw, port, 23, 0x2001);
/* set page register back to 0 */
gm_phy_write(hw, port, PHY_MARV_EXT_ADR, 0);
} else if (hw->chip_id != CHIP_ID_YUKON_EX && } else if (hw->chip_id != CHIP_ID_YUKON_EX &&
hw->chip_id < CHIP_ID_YUKON_SUPR) { hw->chip_id < CHIP_ID_YUKON_SUPR) {
/* no effect on Yukon-XL */ /* no effect on Yukon-XL */
...@@ -2127,6 +2138,25 @@ static void sky2_phy_intr(struct sky2_hw *hw, unsigned port) ...@@ -2127,6 +2138,25 @@ static void sky2_phy_intr(struct sky2_hw *hw, unsigned port)
spin_unlock(&sky2->phy_lock); spin_unlock(&sky2->phy_lock);
} }
/* Special quick link interrupt (Yukon-2 Optima only) */
static void sky2_qlink_intr(struct sky2_hw *hw)
{
struct sky2_port *sky2 = netdev_priv(hw->dev[0]);
u32 imask;
u16 phy;
/* disable irq */
imask = sky2_read32(hw, B0_IMSK);
imask &= ~Y2_IS_PHY_QLNK;
sky2_write32(hw, B0_IMSK, imask);
/* reset PHY Link Detect */
phy = sky2_pci_read16(hw, PSM_CONFIG_REG4);
sky2_pci_write16(hw, PSM_CONFIG_REG4, phy | 1);
sky2_link_up(sky2);
}
/* Transmit timeout is only called if we are running, carrier is up /* Transmit timeout is only called if we are running, carrier is up
* and tx queue is full (stopped). * and tx queue is full (stopped).
*/ */
...@@ -2796,6 +2826,9 @@ static int sky2_poll(struct napi_struct *napi, int work_limit) ...@@ -2796,6 +2826,9 @@ static int sky2_poll(struct napi_struct *napi, int work_limit)
if (status & Y2_IS_IRQ_PHY2) if (status & Y2_IS_IRQ_PHY2)
sky2_phy_intr(hw, 1); sky2_phy_intr(hw, 1);
if (status & Y2_IS_PHY_QLNK)
sky2_qlink_intr(hw);
while ((idx = sky2_read16(hw, STAT_PUT_IDX)) != hw->st_idx) { while ((idx = sky2_read16(hw, STAT_PUT_IDX)) != hw->st_idx) {
work_done += sky2_status_intr(hw, work_limit - work_done, idx); work_done += sky2_status_intr(hw, work_limit - work_done, idx);
...@@ -2845,6 +2878,7 @@ static u32 sky2_mhz(const struct sky2_hw *hw) ...@@ -2845,6 +2878,7 @@ static u32 sky2_mhz(const struct sky2_hw *hw)
case CHIP_ID_YUKON_EX: case CHIP_ID_YUKON_EX:
case CHIP_ID_YUKON_SUPR: case CHIP_ID_YUKON_SUPR:
case CHIP_ID_YUKON_UL_2: case CHIP_ID_YUKON_UL_2:
case CHIP_ID_YUKON_OPT:
return 125; return 125;
case CHIP_ID_YUKON_FE: case CHIP_ID_YUKON_FE:
...@@ -2934,6 +2968,7 @@ static int __devinit sky2_init(struct sky2_hw *hw) ...@@ -2934,6 +2968,7 @@ static int __devinit sky2_init(struct sky2_hw *hw)
break; break;
case CHIP_ID_YUKON_UL_2: case CHIP_ID_YUKON_UL_2:
case CHIP_ID_YUKON_OPT:
hw->flags = SKY2_HW_GIGABIT hw->flags = SKY2_HW_GIGABIT
| SKY2_HW_ADV_POWER_CTL; | SKY2_HW_ADV_POWER_CTL;
break; break;
...@@ -3024,6 +3059,46 @@ static void sky2_reset(struct sky2_hw *hw) ...@@ -3024,6 +3059,46 @@ static void sky2_reset(struct sky2_hw *hw)
sky2_pci_write32(hw, PCI_DEV_REG3, P_CLK_MACSEC_DIS); sky2_pci_write32(hw, PCI_DEV_REG3, P_CLK_MACSEC_DIS);
} }
if (hw->chip_id == CHIP_ID_YUKON_OPT) {
u16 reg;
u32 msk;
if (hw->chip_rev == 0) {
/* disable PCI-E PHY power down (set PHY reg 0x80, bit 7 */
sky2_write32(hw, Y2_PEX_PHY_DATA, (0x80UL << 16) | (1 << 7));
/* set PHY Link Detect Timer to 1.1 second (11x 100ms) */
reg = 10;
} else {
/* set PHY Link Detect Timer to 0.4 second (4x 100ms) */
reg = 3;
}
reg <<= PSM_CONFIG_REG4_TIMER_PHY_LINK_DETECT_BASE;
/* reset PHY Link Detect */
sky2_pci_write16(hw, PSM_CONFIG_REG4,
reg | PSM_CONFIG_REG4_RST_PHY_LINK_DETECT);
sky2_pci_write16(hw, PSM_CONFIG_REG4, reg);
/* enable PHY Quick Link */
msk = sky2_read32(hw, B0_IMSK);
msk |= Y2_IS_PHY_QLNK;
sky2_write32(hw, B0_IMSK, msk);
/* check if PSMv2 was running before */
reg = sky2_pci_read16(hw, PSM_CONFIG_REG3);
if (reg & PCI_EXP_LNKCTL_ASPMC) {
int cap = pci_find_capability(pdev, PCI_CAP_ID_EXP);
/* restore the PCIe Link Control register */
sky2_pci_write16(hw, cap + PCI_EXP_LNKCTL, reg);
}
/* re-enable PEX PM in PEX PHY debug reg. 8 (clear bit 12) */
sky2_write32(hw, Y2_PEX_PHY_DATA, PEX_DB_ACCESS | (0x08UL << 16));
}
/* Clear I2C IRQ noise */ /* Clear I2C IRQ noise */
sky2_write32(hw, B2_I2C_IRQ, 1); sky2_write32(hw, B2_I2C_IRQ, 1);
...@@ -4442,9 +4517,11 @@ static const char *sky2_name(u8 chipid, char *buf, int sz) ...@@ -4442,9 +4517,11 @@ static const char *sky2_name(u8 chipid, char *buf, int sz)
"FE+", /* 0xb8 */ "FE+", /* 0xb8 */
"Supreme", /* 0xb9 */ "Supreme", /* 0xb9 */
"UL 2", /* 0xba */ "UL 2", /* 0xba */
"Unknown", /* 0xbb */
"Optima", /* 0xbc */
}; };
if (chipid >= CHIP_ID_YUKON_XL && chipid < CHIP_ID_YUKON_UL_2) if (chipid >= CHIP_ID_YUKON_XL && chipid < CHIP_ID_YUKON_OPT)
strncpy(buf, name[chipid - CHIP_ID_YUKON_XL], sz); strncpy(buf, name[chipid - CHIP_ID_YUKON_XL], sz);
else else
snprintf(buf, sz, "(chip %#x)", chipid); snprintf(buf, sz, "(chip %#x)", chipid);
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册