BUG: atmel_serial: Interrupts not disabled on close

Since commit 18dfef9c ("serial: atmel: convert to irq handling
provided mctrl-gpio"), interrupts from GPIOs are not disabled any more
when the serial port is closed, leading to an oops when the one of the
input pin is toggled (CTS/DSR/DCD/RNG).

This is only the case if those pins are used as GPIOs, i.e. declared
like that:
usart1: serial@f8020000 {
        /* CTS and DTS will be handled by GPIO */
        status = "okay";
        rts-gpios = <&pioB 17 GPIO_ACTIVE_LOW>;
        cts-gpios = <&pioB 16 GPIO_ACTIVE_LOW>;
        dtr-gpios = <&pioB 14 GPIO_ACTIVE_LOW>;
        dsr-gpios = <&pioC 31 GPIO_ACTIVE_LOW>;
        rng-gpios = <&pioB 12 GPIO_ACTIVE_LOW>;
        dcd-gpios = <&pioB 15 GPIO_ACTIVE_LOW>;
};

That's because modem interrupts used to be freed in atmel_shutdown().
After commit 18dfef9c ("serial: atmel: convert to irq handling
provided mctrl-gpio"), this code was just removed.
Calling atmel_disable_ms() disables the interrupts and everything works
fine again.

Tested on at91sam9g35-cm

(This patch doesn't apply on -stable kernels, fixes for 4.4 and 4.7 will
be sent after this one is applied.)
Signed-off-by: NRichard Genoud <richard.genoud@gmail.com>
Fixes: 18dfef9c ("serial: atmel: convert to irq handling provided mctrl-gpio")
Acked-by: NNicolas Ferre <nicolas.ferre@atmel.com>
Acked-by: NUwe Kleine-König <u.kleine-koenig@pengutronix.de>
Signed-off-by: NGreg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/tty/serial/atmel_serial.c

@@ -1937,6 +1937,9 @@ static void atmel_shutdown(struct uart_port *port)
 {
 	struct atmel_uart_port *atmel_port = to_atmel_uart_port(port);
 
+	/* Disable modem control lines interrupts */
+	atmel_disable_ms(port);
+
 	/* Disable interrupts at device level */
 	atmel_uart_writel(port, ATMEL_US_IDR, -1);
 
@@ -1987,8 +1990,6 @@ static void atmel_shutdown(struct uart_port *port)
 	 */
 	free_irq(port->irq, port);
 
-	atmel_port->ms_irq_enabled = false;
-
 	atmel_flush_buffer(port);
 }