via-rhine: stop using net_device.{base_addr, irq}.

Signed-off-by: NFrancois Romieu <romieu@fr.zoreil.com>
Cc: David Lv <DavidLv@viatech.com.cn>

drivers/net/ethernet/via/via-rhine.c

@@ -687,9 +687,12 @@ static void __devinit rhine_reload_eeprom(long pioaddr, struct net_device *dev)
 #ifdef CONFIG_NET_POLL_CONTROLLER
 static void rhine_poll(struct net_device *dev)
 {
-	disable_irq(dev->irq);
-	rhine_interrupt(dev->irq, (void *)dev);
-	enable_irq(dev->irq);
+	struct rhine_private *rp = netdev_priv(dev);
+	const int irq = rp->pdev->irq;
+
+	disable_irq(irq);
+	rhine_interrupt(irq, dev);
+	enable_irq(irq);
 }
 #endif
 
@@ -970,7 +973,6 @@ static int __devinit rhine_init_one(struct pci_dev *pdev,
 	}
 #endif /* USE_MMIO */
 
-	dev->base_addr = (unsigned long)ioaddr;
 	rp->base = ioaddr;
 
 	/* Get chip registers into a sane state */
@@ -993,8 +995,6 @@ static int __devinit rhine_init_one(struct pci_dev *pdev,
 	if (!phy_id)
 		phy_id = ioread8(ioaddr + 0x6C);
 
-	dev->irq = pdev->irq;
-
 	spin_lock_init(&rp->lock);
 	mutex_init(&rp->task_lock);
 	INIT_WORK(&rp->reset_task, rhine_reset_task);