KVM: VMX: increase ple_gap default to 128

On some CPUs, a ple_gap of 41 is simply insufficient to ever trigger
PLE exits, even with the minimalistic PLE test from kvm-unit-tests.

http://git.kernel.org/?p=virt/kvm/kvm-unit-tests.git;a=commitdiff;h=eda71b28fa122203e316483b35f37aaacd42f545

For example, the Xeon X5670 CPU needs a ple_gap of at least 48 in
order to get pause loop exits:

# modprobe kvm_intel ple_gap=47
# taskset 1 /usr/local/bin/qemu-system-x86_64 \
  -device testdev,chardev=log -chardev stdio,id=log \
  -kernel x86/vmexit.flat -append ple-round-robin -smp 2
VNC server running on `::1:5900'
enabling apic
enabling apic
ple-round-robin 58298446
# rmmod kvm_intel
# modprobe kvm_intel ple_gap=48
# taskset 1 /usr/local/bin/qemu-system-x86_64 \
   -device testdev,chardev=log -chardev stdio,id=log \
   -kernel x86/vmexit.flat -append ple-round-robin -smp 2
VNC server running on `::1:5900'
enabling apic
enabling apic
ple-round-robin 36616

Increase the ple_gap to 128 to be on the safe side.
Signed-off-by: NRik van Riel <riel@redhat.com>
Acked-by: NZhai, Edwin <edwin.zhai@intel.com>
Signed-off-by: NAvi Kivity <avi@redhat.com>

arch/x86/kvm/vmx.c

@@ -93,14 +93,14 @@ module_param(yield_on_hlt, bool, S_IRUGO);
  * These 2 parameters are used to config the controls for Pause-Loop Exiting:
  * ple_gap:    upper bound on the amount of time between two successive
  *             executions of PAUSE in a loop. Also indicate if ple enabled.
- *             According to test, this time is usually small than 41 cycles.
+ *             According to test, this time is usually smaller than 128 cycles.
  * ple_window: upper bound on the amount of time a guest is allowed to execute
  *             in a PAUSE loop. Tests indicate that most spinlocks are held for
  *             less than 2^12 cycles
  * Time is measured based on a counter that runs at the same rate as the TSC,
  * refer SDM volume 3b section 21.6.13 & 22.1.3.
  */
-#define KVM_VMX_DEFAULT_PLE_GAP    41
+#define KVM_VMX_DEFAULT_PLE_GAP    128
 #define KVM_VMX_DEFAULT_PLE_WINDOW 4096
 static int ple_gap = KVM_VMX_DEFAULT_PLE_GAP;
 module_param(ple_gap, int, S_IRUGO);