提交 00185165 编写于 作者: A Andres Salomon 提交者: Linus Torvalds

cs5535-gpio: don't apply errata #36 to edge detect GPIOs

The edge detect status GPIOs function differently from the other atomic
model CS5536 GPIO registers; writing 1 to the high bits clears the GPIO,
but writing 1 to the lower bits also clears the bit.

This means that read-modify-write doesn't actually work for it, so don't
apply the errata here.  If a negative edge status gets lost after
resume..  well, we tried our best!
Tested-by: NDaniel Drake <dsd@laptop.org>
Signed-off-by: NAndres Salomon <dilinger@queued.net>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
上级 e819eb86
......@@ -56,15 +56,22 @@ static struct cs5535_gpio_chip {
* registers, see include/linux/cs5535.h.
*/
static void errata_outl(u32 val, unsigned long addr)
static void errata_outl(struct cs5535_gpio_chip *chip, u32 val,
unsigned int reg)
{
unsigned long addr = chip->base + 0x80 + reg;
/*
* According to the CS5536 errata (#36), after suspend
* a write to the high bank GPIO register will clear all
* non-selected bits; the recommended workaround is a
* read-modify-write operation.
*
* Don't apply this errata to the edge status GPIOs, as writing
* to their lower bits will clear them.
*/
val |= inl(addr);
if (reg != GPIO_POSITIVE_EDGE_STS && reg != GPIO_NEGATIVE_EDGE_STS)
val |= inl(addr);
outl(val, addr);
}
......@@ -76,7 +83,7 @@ static void __cs5535_gpio_set(struct cs5535_gpio_chip *chip, unsigned offset,
outl(1 << offset, chip->base + reg);
else
/* high bank register */
errata_outl(1 << (offset - 16), chip->base + 0x80 + reg);
errata_outl(chip, 1 << (offset - 16), reg);
}
void cs5535_gpio_set(unsigned offset, unsigned int reg)
......@@ -98,7 +105,7 @@ static void __cs5535_gpio_clear(struct cs5535_gpio_chip *chip, unsigned offset,
outl(1 << (offset + 16), chip->base + reg);
else
/* high bank register */
errata_outl(1 << offset, chip->base + 0x80 + reg);
errata_outl(chip, 1 << offset, reg);
}
void cs5535_gpio_clear(unsigned offset, unsigned int reg)
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册