Some PWMs are disabled by default or the default pin setting
does not match the LED_OFF state (e.g., active-low leds).
Hence, the driver may end up reporting 0 brightness, but
the leds are actually on using full brightness, because
it never enforces its default configuration.
So enforce it by calling led_pwm_set() after successfully
registering the device.

Tested on a Phytec phyFLEX i.MX6Q board based on kernel
v3.19.5.
Signed-off-by: NMarkus Hofstaetter <markus.hofstaetter@ait.ac.at>
Tested-by: NMarkus Hofstaetter <markus.hofstaetter@ait.ac.at>
Signed-off-by: NJacek Anaszewski <j.anaszewski@samsung.com>