• M
    ARM: shmobile: INTC External IRQ pin driver on sh73a0 · 341eb546
    Magnus Damm 提交于
    Adjust the sh73a0 IRQ code to make use of the
    INTC External IRQ pin driver for external
    interrupt pins IRQ0 -> IRQ31.
    
    This removes quite a bit of special-case code
    in intc-sh73a0.c but the number of lines get
    replaced with platform device information in
    setup-sh73a0.c. The PFC code is also adjusted
    to make gpio_to_irq() return the correct
    interrupt number.
    
    At this point the DT reference implementations
    are not covered. In the future such code shall
    tie in the INTC External IRQ pin driver via
    DT, so this kind of verbose code is not needed
    for the long term DT case.
    Signed-off-by: NMagnus Damm <damm@opensource.se>
    Signed-off-by: NSimon Horman <horms+renesas@verge.net.au>
    341eb546
intc-sh73a0.c 13.1 KB