-
由 Liran Alon 提交于
When L1 IOAPIC redirection-table is written, a request of KVM_REQ_SCAN_IOAPIC is set on all vCPUs. This is done such that all vCPUs will now recalc their IOAPIC handled vectors and load it to their EOI-exitmap. However, it could be that one of the vCPUs is currently running L2. In this case, load_eoi_exitmap() will be called which would write to vmcs02->eoi_exit_bitmap, which is wrong because vmcs02->eoi_exit_bitmap should always be equal to vmcs12->eoi_exit_bitmap. Furthermore, at this point KVM_REQ_SCAN_IOAPIC was already consumed and therefore we will never update vmcs01->eoi_exit_bitmap. This could lead to remote_irr of some IOAPIC level-triggered entry to remain set forever. Fix this issue by delaying the load of EOI-exitmap to when vCPU is running L1. One may wonder why not just delay entire KVM_REQ_SCAN_IOAPIC processing to when vCPU is running L1. This is done in order to handle correctly the case where LAPIC & IO-APIC of L1 is pass-throughed into L2. In this case, vmcs12->virtual_interrupt_delivery should be 0. In current nVMX implementation, that results in vmcs02->virtual_interrupt_delivery to also be 0. Thus, vmcs02->eoi_exit_bitmap is not used. Therefore, every L2 EOI cause a #VMExit into L0 (either on MSR_WRITE to x2APIC MSR or APIC_ACCESS/APIC_WRITE/EPT_MISCONFIG to APIC MMIO page). In order for such L2 EOI to be broadcasted, if needed, from LAPIC to IO-APIC, vcpu->arch.ioapic_handled_vectors must be updated while L2 is running. Therefore, patch makes sure to delay only the loading of EOI-exitmap but not the update of vcpu->arch.ioapic_handled_vectors. Reviewed-by: NArbel Moshe <arbel.moshe@oracle.com> Reviewed-by: NKrish Sadhukhan <krish.sadhukhan@oracle.com> Signed-off-by: NLiran Alon <liran.alon@oracle.com> Signed-off-by: NPaolo Bonzini <pbonzini@redhat.com>
e40ff1d6