-
由 Masahiro Yamada 提交于
Introduce some macros and helpers to avoid magic numbers and rename macros/functions for clarification. - We see '| 2' in several places. This means Data Cycle in MAP11 mode. The Denali User's Guide says bit[1:0] of MAP11 is like follows: b'00 = Command Cycle b'01 = Address Cycle b'10 = Data Cycle So, this commit added DENALI_MAP11_{CMD,ADDR,DATA} macros. - We see 'denali->flash_mem + 0x10' in several places, but 0x10 is a magic number. Actually, this accesses the data port of the Host Data/Command Interface. So, this commit added DENALI_HOST_DATA. On the other hand, 'denali->flash_mem' gets access to the address port, so DENALI_HOST_ADDR was also added. - We see 'index_addr(denali, cmd, 0x1)' in denali_erase(), but 0x1 is a magic number. 0x1 means the erase operation. Replace 0x1 with DENALI_ERASE. - Rename index_addr() to denali_host_write() for clarification - Denali User's Guide says MAP{00,01,10,11} for access mode. Match the macros with terminology in the IP document. - Rename struct members as follows: flash_bank -> active_bank (currently selected bank) flash_reg -> reg (base address of registers) flash_mem -> host (base address of host interface) devnum -> devs_per_cs (devices connected in parallel) bbtskipbytes -> oob_skip_bytes (number of bytes to skip in OOB) Signed-off-by: NMasahiro Yamada <yamada.masahiro@socionext.com> Signed-off-by: NBoris Brezillon <boris.brezillon@free-electrons.com>
0d3a966d