• K
    md: the md RAID10 resync thread could cause a md RAID10 array deadlock · a07e6ab4
    K.Tanaka 提交于
    This message describes another issue about md RAID10 found by testing the
    2.6.24 md RAID10 using new scsi fault injection framework.
    
    Abstract:
    
    When a scsi error results in disabling a disk during RAID10 recovery, the
    resync threads of md RAID10 could stall.
    
    This case, the raid array has already been broken and it may not matter.  But
    I think stall is not preferable.  If it occurs, even shutdown or reboot will
    fail because of resource busy.
    
    The deadlock mechanism:
    
    The r10bio_s structure has a "remaining" member to keep track of BIOs yet to
    be handled when recovering.  The "remaining" counter is incremented when
    building a BIO in sync_request() and is decremented when finish a BIO in
    end_sync_write().
    
    If building a BIO fails for some reasons in sync_request(), the "remaining"
    should be decremented if it has already been incremented.  I found a case
    where this decrement is forgotten.  This causes a md_do_sync() deadlock
    because md_do_sync() waits for md_done_sync() called by end_sync_write(), but
    end_sync_write() never calls md_done_sync() because of the "remaining" counter
    mismatch.
    
    For example, this problem would be reproduced in the following case:
    
    Personalities : [raid10]
    md0 : active raid10 sdf1[4] sde1[5](F) sdd1[2] sdc1[1] sdb1[6](F)
          3919616 blocks 64K chunks 2 near-copies [4/2] [_UU_]
          [>....................]  recovery =  2.2% (45376/1959808) finish=0.7min speed=45376K/sec
    
    This case, sdf1 is recovering, sdb1 and sde1 are disabled.
    An additional error with detaching sdd will cause a deadlock.
    
    md0 : active raid10 sdf1[4] sde1[5](F) sdd1[6](F) sdc1[1] sdb1[7](F)
          3919616 blocks 64K chunks 2 near-copies [4/1] [_U__]
          [=>...................]  recovery =  5.0% (99520/1959808) finish=5.9min speed=5237K/sec
    
     2739 ?        S<     0:17 [md0_raid10]
    28608 ?        D<     0:00 [md0_resync]
    28629 pts/1    Ss     0:00 bash
    28830 pts/1    R+     0:00 ps ax
    31819 ?        D<     0:00 [kjournald]
    
    The resync thread keeps working, but actually it is deadlocked.
    
    Patch:
    By this patch, the remaining counter will be decremented if needed.
    Signed-off-by: NNeil Brown <neilb@suse.de>
    Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
    Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>
    a07e6ab4
raid10.c 59.5 KB