-
由 Yoshihiro Shimoda 提交于
This patch adds sysfs "role" for usb role swap. This parameter can be read and write. If you use this file as the following, you can swap the usb role. For example: 1) Connect a usb cable using 2 Salvator-x boards 2) On A-Device (ID pin is low), you input the following command: # echo peripheral > /sys/devices/platform/soc/ee080200.usb-phy/role 3) On B-Device (ID pin is high), you input the following command: # echo host > /sys/devices/platform/soc/ee080200.usb-phy/role Then, the A-device acts as a peripheral and the B-device acts as a host. Please note that A-Device must input the following command if you want the board to act as a host again. (even if you disconnect the usb cable, since id state may be the same, the A-Device keeps to act as peripheral.) # echo host > /sys/devices/platform/soc/ee080200.usb-phy/role Signed-off-by: NYoshihiro Shimoda <yoshihiro.shimoda.uh@renesas.com> Reviewed-by: NPeter Chen <peter.chen@nxp.com> Signed-off-by: NKishon Vijay Abraham I <kishon@ti.com>
9bb86777