-
由 Keller, Jacob E 提交于
Ethernet drivers implementing both {GS}RXFH and {GS}CHANNELS ethtool ops incorrectly allow SCHANNELS when it would conflict with the settings from SRXFH. This occurs because it is not possible for drivers to understand whether their Rx flow indirection table has been configured or is in the default state. In addition, drivers currently behave in various ways when increasing the number of Rx channels. Some drivers will always destroy the Rx flow indirection table when this occurs, whether it has been set by the user or not. Other drivers will attempt to preserve the table even if the user has never modified it from the default driver settings. Neither of these situation is desirable because it leads to unexpected behavior or loss of user configuration. The correct behavior is to simply return -EINVAL when SCHANNELS would conflict with the current Rx flow table settings. However, it should only do so if the current settings were modified by the user. If we required that the new settings never conflict with the current (default) Rx flow settings, we would force users to first reduce their Rx flow settings and then reduce the number of Rx channels. This patch proposes a solution implemented in net/core/ethtool.c which ensures that all drivers behave correctly. It checks whether the RXFH table has been configured to non-default settings, and stores this information in a private netdev flag. When the number of channels is requested to change, it first ensures that the current Rx flow table is not going to assign flows to now disabled channels. Signed-off-by: NJacob Keller <jacob.e.keller@intel.com> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
d4ab4286