• A
    OHCI: work around for nVidia shutdown problem · 3df7169e
    Alan Stern 提交于
    This patch (as1417) fixes a problem affecting some (or all) nVidia
    chipsets.  When the computer is shut down, the OHCI controllers
    continue to power the USB buses and evidently they drive a Reset
    signal out all their ports.  This prevents attached devices from going
    to low power.  Mouse LEDs stay on, for example, which is disconcerting
    for users and a drain on laptop batteries.
    
    The fix involves leaving each OHCI controller in the OPERATIONAL state
    during system shutdown rather than putting it in the RESET state.
    Although this nominally means the controller is running, in fact it's
    not doing very much since all the schedules are all disabled.  However
    there is ongoing DMA to the Host Controller Communications Area, so
    the patch also disables the bus-master capability of all PCI USB
    controllers after the shutdown routine runs.
    
    The fix is applied only to nVidia-based PCI OHCI controllers, so it
    shouldn't cause problems on systems using other hardware.  As an added
    safety measure, in case the kernel encounters one of these running
    controllers during boot, the patch changes quirk_usb_handoff_ohci()
    (which runs early on during PCI discovery) to reset the controller
    before anything bad can happen.
    Reported-by: NPali Rohár <pali.rohar@gmail.com>
    Signed-off-by: NAlan Stern <stern@rowland.harvard.edu>
    CC: David Brownell <david-b@pacbell.net>
    Tested-by: NPali Rohár <pali.rohar@gmail.com>
    CC: stable <stable@kernel.org>
    Signed-off-by: NGreg Kroah-Hartman <gregkh@suse.de>
    3df7169e
hcd-pci.c 14.7 KB