- 16 1月, 2022 1 次提交
-
-
由 Wayne 提交于
* Update drivers. 1. Improve LVGL avg FPS. 2. Sync configuration to 4.1.0. * [Nuvoton] Update drivers. 1. Fix open-control order issue in CAN driver. 2. [N9H30] Improve N9H30 I2C busy-wait implementation. 3. [N9H30] Support 1024x600x32b LCD panel. 4. Move nu_packages menu into sub-menu of board. * Update menu-option. 1. Set BOARD_USING_LCM is on by default. 2. Fix default value setting in choice-option. * Fix control function in I2C driver. * Add sdk_dist.py and ADC touching calibration function. Co-authored-by: NWayne Lin <wclin@nuvoton.com>
-
- 12 5月, 2021 1 次提交
-
-
由 Wayne Lin 提交于
-
- 15 3月, 2021 1 次提交
-
-
由 Wayne Lin 提交于
1. Add NUC980 Chili board supporting. 2. Correct NuMicro.h including. 3. Implement rt_hw_us_delay system call function. 4. Move board.c to drv_common.c for M480 and M2354 series.
-
- 29 12月, 2020 1 次提交
-
-
由 Wayne Lin 提交于
1. Add 980 drv_usbd. 2. EMAC - move MDC CLK divider before EMAC initialization. 3. Correct NUC980 and M480 CAN RX_MSG_ID_INDEX definition. 4. add USBD cdc demo - vcom_echo. 5. mnt - add mount_table definition.
-
- 25 12月, 2020 1 次提交
-
-
由 Wayne Lin 提交于
1. Fix porting driver. 2. Add NAU8822 audio codec driver. 3. Add NUC980 I2S porting driver.
-
- 21 12月, 2020 1 次提交
-
-
由 Wayne Lin 提交于
1. Make up sources and bugfix. 2. Add nu_gpio_pin_get. 3. Add PM operator in USB host driver. 4. Support NUC980 stage 1 and add nk-980iot board.
-
- 03 8月, 2020 1 次提交
-
-
由 Wayne Lin 提交于
2. Fix spi/qspi/uspi TX/RX PDMA trigger issue. 3. Drain RX FIFO to remove remain FEF frames in FIFO. 4. Implement RT_DEVICE_CTRL_CLOSE in uart/uuart/scuart driver.
-
- 17 6月, 2020 1 次提交
-
-
由 Wayne Lin 提交于
-