提交 b989e138 编写于 作者: B Benoit Cousson 提交者: Simon Horman

ARM: shmobile: r8a7790/lager dts: Add DVFS parameters into cpu0 node for r8a7790

Add needed information inside CPU0 for the generic cpufreq-cpu0 driver.

- voltage-tolerance = 1%
  It reflects the tolerance for the CPU voltage defined inside the OPP
  table. Due to the lack of proper OPP definition, use an arbitrary safe
  value.
- clock-latency = 300 us
  Approximate worst-case latency to do a full DVFS transition for every
  OPPs. Due to the lack of HW information, use an arbitrary safe value.
  Note: The term transition-latency will be more accurate to define this
  value since the clock transition latency is not the only parameter that
  will define the overall DVFS transition.
- operating-points = < kHz - uV >
  List of 6 operating points. All of them are using the same voltage
  since the valid Vmin voltage is not documented in the HW spec.
- clocks
  phandle to the CPU clock source. This clock source is used for all the
  4 CortexA15 located inside the same cluster.
Signed-off-by: NBenoit Cousson <bcousson+renesas@baylibre.com>
[gaku.inami.xw@bp.renesas.com: Change the setting of OPPs for ES2.0]
Signed-off-by: NGaku Inami <gaku.inami.xw@bp.renesas.com>
Acked-by: NMagnus Damm <damm@opensource.se>
Signed-off-by: NSimon Horman <horms+renesas@verge.net.au>
上级 05f72e03
......@@ -338,3 +338,7 @@
regulator-always-on;
};
};
&cpu0 {
cpu0-supply = <&vdd_dvfs>;
};
......@@ -44,6 +44,17 @@
compatible = "arm,cortex-a15";
reg = <0>;
clock-frequency = <1300000000>;
voltage-tolerance = <1>; /* 1% */
clocks = <&cpg_clocks R8A7790_CLK_Z>;
clock-latency = <300000>; /* 300 us */
/* kHz - uV - OPPs unknown yet */
operating-points = <1400000 1000000>,
<1225000 1000000>,
<1050000 1000000>,
< 875000 1000000>,
< 700000 1000000>,
< 350000 1000000>;
};
cpu1: cpu@1 {
......
Markdown is supported
0% .
You are about to add 0 people to the discussion. Proceed with caution.
先完成此消息的编辑!
想要评论请 注册