- 08 1月, 2006 2 次提交
-
-
由 Patrick McHardy 提交于
ip_route_me_harder doesn't use the port numbers of the xfrm lookup and uses ip_route_input for non-local addresses which doesn't do a xfrm lookup, ip6_route_me_harder doesn't do a xfrm lookup at all. Use xfrm_decode_session and do the lookup manually, make sure both only do the lookup if the packet hasn't been transformed already. Makeing sure the lookup only happens once needs a new field in the IP6CB, which exceeds the size of skb->cb. The size of skb->cb is increased to 48b. Apparently the IPv6 mobile extensions need some more room anyway. Signed-off-by: NPatrick McHardy <kaber@trash.net> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
由 Patrick McHardy 提交于
Reset IPSKB_XFRM_TUNNEL_SIZE flags in ipip and ip_gre hard_start_xmit function before the packet reenters IP. This is neccessary so the encapsulated packets are checked not to be oversized in xfrm4_output.c again. Reset all flags in sit when a packet changes its address family. Also remove some obsolete IPSKB flags. Signed-off-by: NPatrick McHardy <kaber@trash.net> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 06 1月, 2006 1 次提交
-
-
由 Kris Katterjohn 提交于
These patches add the header linux/if_ether.h and change 1500 to ETH_DATA_LEN in some files. Signed-off-by: NKris Katterjohn <kjak@users.sourceforge.net> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 15 12月, 2005 1 次提交
-
-
由 Herbert Xu 提交于
The skb_postpull_rcsum introduced a bug to the checksum modification. Although the length pulled is offset bytes, the origin of the pulling is the GRE header, not the IP header. Signed-off-by: NHerbert Xu <herbert@gondor.apana.org.au> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 30 11月, 2005 1 次提交
-
-
由 Adrian Bunk 提交于
This patch makes two needlessly global functions static. Signed-off-by: NAdrian Bunk <bunk@stusta.de> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 11 11月, 2005 1 次提交
-
-
由 Herbert Xu 提交于
Here is the patch that introduces the generic skb_checksum_complete which also checks for hardware RX checksum faults. If that happens, it'll call netdev_rx_csum_fault which currently prints out a stack trace with the device name. In future it can turn off RX checksum. I've converted every spot under net/ that does RX checksum checks to use skb_checksum_complete or __skb_checksum_complete with the exceptions of: * Those places where checksums are done bit by bit. These will call netdev_rx_csum_fault directly. * The following have not been completely checked/converted: ipmr ip_vs netfilter dccp This patch is based on patches and suggestions from Stephen Hemminger and David S. Miller. Signed-off-by: NHerbert Xu <herbert@gondor.apana.org.au> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 04 10月, 2005 1 次提交
-
-
由 Herbert Xu 提交于
The following patch renames __in_dev_get() to __in_dev_get_rtnl() and introduces __in_dev_get_rcu() to cover the second case. 1) RCU with refcnt should use in_dev_get(). 2) RCU without refcnt should use __in_dev_get_rcu(). 3) All others must hold RTNL and use __in_dev_get_rtnl(). There is one exception in net/ipv4/route.c which is in fact a pre-existing race condition. I've marked it as such so that we remember to fix it. This patch is based on suggestions and prior work by Suzanne Wood and Paul McKenney. Signed-off-by: NHerbert Xu <herbert@gondor.apana.org.au> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 31 7月, 2005 1 次提交
-
-
由 Alexey Kuznetsov 提交于
Tunnel modules used to obtain module refcount each time when some tunnel was created, which meaned that tunnel could be unloaded only after all the tunnels are deleted. Since killing old MOD_*_USE_COUNT macros this protection has gone. It is possible to return it back as module_get/put, but it looks more natural and practically useful to force destruction of all the child tunnels on module unload. Signed-off-by: NAlexey Kuznetsov <kuznet@ms2.inr.ac.ru> Signed-off-by: NDavid S. Miller <davem@davemloft.net>
-
- 17 4月, 2005 1 次提交
-
-
由 Linus Torvalds 提交于
Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip!
-