rapidio: apply RX/TX enable to active switch ports only

Apply port RX/TX enable operations only to active switch ports.

RapidIO specification (Part 6: LP-Serial Physical Layer) recommends to
keep Output Port Enable (TX) and Input Port Enable (RX) control bits in
disabled state (0b0) after device reset.  It also allows to have
implementation specific reset state for these bits.

This patch ensures that TX/RX enable action is applied only to active
switch's ports while preserving an initial state of inactive ones.

This patch is intended to keep inactive switch ports with inbound and
outbound packet transfers disabled to block unexpected packets during hot
insertion event.  While it does not fix any visible malfunction it is
intended to prevent such events in future.
Signed-off-by: NAlexandre Bounine <alexandre.bounine@idt.com>
Cc: Matt Porter <mporter@kernel.crashing.org>
Signed-off-by: NAndrew Morton <akpm@linux-foundation.org>
Signed-off-by: NLinus Torvalds <torvalds@linux-foundation.org>

drivers/rapidio/rio-scan.c

@@ -839,12 +839,10 @@ static int __devinit rio_enum_peer(struct rio_net *net, struct rio_mport *port,
 		for (port_num = 0;
 		     port_num < RIO_GET_TOTAL_PORTS(rdev->swpinfo);
 		     port_num++) {
-			/*Enable Input Output Port (transmitter reviever)*/
-			rio_enable_rx_tx_port(port, 0,
+			if (sw_inport == port_num) {
+				rio_enable_rx_tx_port(port, 0,
 					      RIO_ANY_DESTID(port->sys_size),
 					      hopcount, port_num);
-
-			if (sw_inport == port_num) {
 				rdev->rswitch->port_ok |= (1 << port_num);
 				continue;
 			}
@@ -857,6 +855,9 @@ static int __devinit rio_enum_peer(struct rio_net *net, struct rio_mport *port,
 				pr_debug(
 				    "RIO: scanning device on port %d\n",
 				    port_num);
+				rio_enable_rx_tx_port(port, 0,
+					      RIO_ANY_DESTID(port->sys_size),
+					      hopcount, port_num);
 				rdev->rswitch->port_ok |= (1 << port_num);
 				rio_route_add_entry(rdev, RIO_GLOBAL_TABLE,
 						RIO_ANY_DESTID(port->sys_size),