i40e: Fix unqualified module message while bringing link up

In current driver, when ifconfig ethx up is done, the link state
doesn't transition to UP inside i40e_open(). It changes after AQ
command response is handled in i40e_handle_link_event().

When pf->hw.phy.link_info.link_info is DOWN inside i40e_open(),
The state is transient and invalid. So log message gets printed
based on incorrect info (i.e link_info and an_info).

This commit removes check for unqualified module inside
i40e_up_complete(). The existing check in i40e_handle_link_event()
logs the error message based on correct link state information.
Signed-off-by: NSudheer Mogilappagari <sudheer.mogilappagari@intel.com>
Tested-by: NAndrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: NJeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/i40e/i40e_main.c

@@ -5470,15 +5470,6 @@ static int i40e_up_complete(struct i40e_vsi *vsi)
 		i40e_print_link_message(vsi, true);
 		netif_tx_start_all_queues(vsi->netdev);
 		netif_carrier_on(vsi->netdev);
-	} else if (vsi->netdev) {
-		i40e_print_link_message(vsi, false);
-		/* need to check for qualified module here*/
-		if ((pf->hw.phy.link_info.link_info &
-			I40E_AQ_MEDIA_AVAILABLE) &&
-		    (!(pf->hw.phy.link_info.an_info &
-			I40E_AQ_QUALIFIED_MODULE)))
-			netdev_err(vsi->netdev,
-				   "the driver failed to link because an unqualified module was detected.");
 	}
 
 	/* replay FDIR SB filters */